how to reset tire pressure monitoring system (TPMS) in Toyota Camry XV70 (2018-2024)

Toyota Camry XV80 (2025-Present)

Error Codes

30 minutes

Time

easy

Difficulty

medium

Severity

2 min read

362 words

Problem Statement

Learn how to reset the TPMS in Toyota Camry XV70 (2018-2024) with this easy guide. Step-by-step instructions and diagnostic tips included.

Affected Component

Electrical

Estimated Time

30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Always ensure tires are at the correct pressure before resetting TPMS to avoid driving on under-inflated tires.

Symptoms

•TPMS warning light illuminated on the dashboard
•Inaccurate tire pressure readings displayed
•Warning message indicating low tire pressure

Diagnostic Steps

1
Check the current tire pressures using a tire pressure gauge to ensure they are at the recommended levels.
2
Inspect each tire for visible damage or punctures that may affect pressure.
3
Confirm if the TPMS warning light is on after correcting the tire pressures.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Tire pressure gauge
•OBD-II scanner

Parts Required

•None

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Ensure all tires are inflated to the manufacturer’s recommended pressure.
Gather necessary tools: tire pressure gauge, OBD-II scanner (if needed for advanced resetting).

2. Resetting TPMS

Turn on the Ignition: Insert the key and turn it to the "ON" position without starting the engine.
Locate the TPMS Reset Button: The reset button is usually located beneath the steering wheel or near the driver's side door.
Press and Hold the TPMS Reset Button: Hold the button down until the TPMS light blinks three times and then turns off. This usually takes about 3 seconds.
Start the Engine: Start the vehicle and allow it to run for about 20 minutes, which enables the system to recalibrate.
Check for Warning Light: After driving, check if the TPMS warning light is still illuminated. If it is off, the reset was successful.

Tools Required

Tire pressure gauge

Parts Required

None