how to reset the maintenance light on Toyota Camry XV40 (2007-2011)

Toyota Camry XV80 (2025-Present)

5-10 minutes

Time

easy

Difficulty

low

Severity

2 min read

359 words

Problem Statement

Learn how to reset the maintenance light on a 2007-2011 Toyota Camry XV40. Step-by-step guide with diagnostic steps and verification procedures.

Affected Component

Electrical

Estimated Time

5-10 minutes

Important safety information - read before proceeding

•Ensure the vehicle is in 'Park' or 'Neutral' with the parking brake engaged while performing this procedure.

•Maintenance light illuminated on the dashboard
•Reminder for oil change or service due displayed on the Multi-Information Display
•No engine performance issues associated

1
Ensure the vehicle is parked on a level surface and the engine is off.
2
Turn the ignition switch to the 'ON' position without starting the engine.
3
Verify that the odometer is displayed, not the trip meter.
4
If necessary, press the trip meter button to switch to the odometer display.
5
Turn the ignition switch off again.
6
While holding the trip meter button, turn the ignition switch back to the 'ON' position.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Ensure the vehicle is parked on a level surface and the engine is off.
2
Turn the ignition switch to the 'ON' position without starting the engine.
3
Verify that the odometer is displayed, not the trip meter.
4
If necessary, press the trip meter button to switch to the odometer display.
5
Turn the ignition switch off again.
6
While holding the trip meter button, turn the ignition switch back to the 'ON' position.

Solution

1. Preparation

2. Resetting the Maintenance Light

With the ignition in the "OFF" position, press and hold the trip meter button.
While holding the trip meter button, turn the ignition switch to the "ON" position (do not start the engine).
Continue to hold the trip meter button until the maintenance light blinks and then turns off, which usually takes about 10 seconds.
Release the trip meter button.
Turn the ignition switch to the "OFF" position and then back to "ON" to verify that the maintenance light is no longer illuminated.