my Toyota Camry XV50 (2012-2017) has a clicking noise when turning what should I do

Toyota Camry XV70 (2018-2024)

Error Codes

2-4 hours

Time

medium

Difficulty

high

Severity

3 min read

537 words

⚠️ Safety Warning

This issue requires immediate attention. If you are not experienced with automotive repairs, consult a professional mechanic. Working on critical systems can be dangerous.

Problem Statement

Learn how to diagnose and fix clicking noise when turning in Toyota Camry XV50. Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Suspension

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is securely supported on jack stands before working underneath.
•Disconnect the battery to prevent electrical shorts while working on components.

Symptoms

•Clicking sound when steering left or right
•Noise increases with speed
•Vibration felt in the steering wheel
•Possible loss of steering control during turns
•Check for any abnormal tire wear patterns

Diagnostic Steps

1
Inspect outer CV joints for wear and damage.
2
Check inner CV joints for play or signs of wear.
3
Examine suspension components, including struts and control arms, for any damage or looseness.
4
Inspect wheel bearings for excessive play or noise.
5
Verify tire condition and alignment status.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Jack and jack stands
•Socket set
•Torque wrench
•CV joint puller
•Spring compressor

Parts Required

•Outer CV joint assembly
•Inner CV joint assembly (if needed)
•Suspension components (if damaged)
•Wheel bearings (if worn)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather necessary tools and parts.
Park the vehicle on a flat surface and engage the parking brake.
Disconnect the negative battery terminal for safety.

2. Inspect and Replace CV Joints

Lift the Vehicle: Use a jack to lift the front of the vehicle and secure it with jack stands.
Remove the Wheel: Use a socket set to remove the lug nuts and take off the wheel.
Examine CV Joint Boot: Check the boot for tears or leaks. If damaged, it may need replacement.
Test CV Joint: With the wheel off, grab the CV joint and try to move it; it should not have excessive play.
Replace the CV Joint (if necessary):
- Remove the axle nut using a socket and breaker bar.
- Detach the CV joint from the transmission or differential.
- Install the new CV joint by reversing the removal process.
- Torque the axle nut to the manufacturer’s specifications (typically around 150 ft-lbs).

3. Inspect Suspension Components

Check Struts and Control Arms: Look for any signs of damage or excessive wear.
Replace Damaged Parts: If struts or control arms are damaged, replace them following the appropriate procedures.
- Use a spring compressor if necessary to safely remove and install struts.
- Torque all bolts to the manufacturer’s specifications.

4. Wheel Bearing Inspection

Check Bearing Play: Spin the wheel and listen for noise or feel for roughness.
Replace Wheel Bearings (if needed):
- Remove the brake rotor and caliper.
- Use a bearing puller to remove the old bearing.
- Install the new bearing and reassemble the brake components.