how to reset the maintenance light on my Toyota Camry XV50 (2012-2017)

Toyota Camry XV70 (2018-2024)

10 minutes

Time

easy

Difficulty

low

Severity

3 min read

410 words

Problem Statement

Learn how to reset the maintenance light on your 2012-2017 Toyota Camry XV50. Step-by-step guide for a quick and easy reset procedure.

Affected Component

Electrical

Estimated Time

10 minutes

Important safety information - read before proceeding

•Ensure the vehicle is in park and on a flat surface before performing the reset.

1
Ensure the vehicle is parked, and the ignition is in the OFF position.
2
Open the driver's door to ensure the vehicle is in an accessible state.
3
Insert the key into the ignition without starting the engine (for traditional key models) or ensure the push-button start is in the OFF position (for keyless entry models).
4
Press the gas pedal three times within five seconds.
5
Turn the ignition to the ON position (do not start the engine).
6
Observe the maintenance light blinking and then turning off.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Ensure the vehicle is parked, and the ignition is in the OFF position.
2
Open the driver's door to ensure the vehicle is in an accessible state.
3
Insert the key into the ignition without starting the engine (for traditional key models) or ensure the push-button start is in the OFF position (for keyless entry models).
4
Press the gas pedal three times within five seconds.
5
Turn the ignition to the ON position (do not start the engine).
6
Observe the maintenance light blinking and then turning off.

Solution

1. Preparation

2. Resetting the Maintenance Light

Access the Ignition
- Insert the key into the ignition or ensure the push-button start is off.
Press the Gas Pedal
- Fully depress the gas pedal three times within five seconds without starting the engine.
Turn the Ignition On
- Turn the ignition key to the ON position (or press the start button twice without pressing the brake pedal) to power the electrical systems without engaging the engine.
Observe the Maintenance Light
- Watch for the maintenance light to blink and then extinguish after a few seconds.
Verify the Reset
- Turn the ignition back to the OFF position and then to the ON position again to ensure the maintenance light remains off.