how to reset the maintenance light on my Toyota Camry Eighth Generation (2018-present)

Toyota Camry Eighth Generation (2018-present)

Error Codes

5-10 minutes

Time

easy

Difficulty

low

Severity

3 min read

407 words

Problem Statement

Learn how to reset the maintenance light on your Toyota Camry (2018-2023) with this step-by-step guide. Ensure your vehicle's maintenance reminders are accurate.

Affected Component

Electrical

Estimated Time

5-10 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in park and on a level surface while performing this procedure.

Symptoms

•Maintenance light illuminated on the dashboard
•Service reminder notification on the display
•Vehicle does not indicate a scheduled service is due

Diagnostic Steps

1
Turn the ignition switch to the 'ON' position without starting the engine.
2
Press the 'ODO/TRIP' button until the odometer is displayed.
3
Turn the ignition switch off.
4
While holding the 'ODO/TRIP' button, turn the ignition switch back to the 'ON' position.
5
Continue holding the 'ODO/TRIP' button until the maintenance light resets.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•None required, but a vehicle owner's manual may be helpful.

Parts Required

•None required for resetting the maintenance light.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Turn the ignition switch to the 'ON' position without starting the engine.
2
Press the 'ODO/TRIP' button until the odometer is displayed.
3
Turn the ignition switch off.
4
While holding the 'ODO/TRIP' button, turn the ignition switch back to the 'ON' position.
5
Continue holding the 'ODO/TRIP' button until the maintenance light resets.

Solution

1. Preparation

Ensure the vehicle is in a safe location with the ignition off.
Have the vehicle’s owner's manual on hand for reference if needed.

2. Turn Ignition On

Insert the key into the ignition.
Turn the ignition switch to the "ON" position without starting the engine.

3. Set Odometer to Trip Mode

Locate the "ODO/TRIP" button on the dashboard.
Press the "ODO/TRIP" button until the odometer displays the trip meter (TRIP A or TRIP B).

4. Turn Ignition Off

Turn the ignition switch off again.

5. Reset the Maintenance Light

Press and hold the "ODO/TRIP" button.
While holding the button, turn the ignition switch to "ON" again.
Continue holding the button until the maintenance light on the dashboard blinks and then turns off (this may take a few seconds).

6. Confirm Reset

Release the "ODO/TRIP" button.
Turn off the ignition and then turn it back to "ON" to verify that the maintenance light is no longer illuminated.