how to reset the tire pressure light on Toyota Camry Seventh Generation (2012-2017)

Toyota Camry Seventh Generation (2012-2017)

15-30 minutes

Time

easy

Difficulty

medium

Severity

3 min read

445 words

Problem Statement

Learn how to reset the tire pressure light on Toyota Camry (2012-2017). Step-by-step guide with diagnostic steps and solutions for TPMS issues.

Affected Component

Electrical

Estimated Time

15-30 minutes

Important safety information - read before proceeding

•Ensure the vehicle is in a safe and stable position before working on tire pressures.

1
Verify that all tires, including the spare, are inflated to the recommended pressure listed on the driver’s side door jamb.
2
Check for any visible damage or leaks in the tire or valve stem.
3
Use an OBD-II scanner to check for any stored TPMS fault codes that may indicate a malfunctioning sensor.
4
Inspect the TPMS sensors for proper installation if tires have been replaced or rotated.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Verify that all tires, including the spare, are inflated to the recommended pressure listed on the driver’s side door jamb.
2
Check for any visible damage or leaks in the tire or valve stem.
3
Use an OBD-II scanner to check for any stored TPMS fault codes that may indicate a malfunctioning sensor.
4
Inspect the TPMS sensors for proper installation if tires have been replaced or rotated.

Solution

1. Preparation

2. Resetting the Tire Pressure Light

Locate the TPMS Reset Button:
- Find the TPMS reset button, which is usually located under the steering wheel or in the glove compartment.
Turn the Ignition On:
- Turn the ignition key to the "ON" position without starting the engine. For push-start models, press the start button twice without pressing the brake pedal.
Press the TPMS Reset Button:
- Press and hold the TPMS reset button until the TPMS warning light blinks three times, then release the button.
Start the Engine:
- Start the engine and allow it to run for about 20 minutes. This allows the system to recalibrate and recognize the new tire pressures.
Check for Warning Light:
- After driving the vehicle, ensure the tire pressure light has turned off. If it remains illuminated, repeat the reset procedure.