how to reset the maintenance light on a Toyota Camry Seventh Generation (2012-2017)

Toyota Camry Seventh Generation (2012-2017)

5 minutes

Time

easy

Difficulty

low

Severity

2 min read

332 words

Problem Statement

Learn how to reset the maintenance light on a 2012-2017 Toyota Camry. Step-by-step guide with diagnostic procedures and reset instructions.

Affected Component

Electrical

Estimated Time

5 minutes

Important safety information - read before proceeding

•Ensure the vehicle is in 'Park' (or 'Neutral' for manual transmissions) before starting the reset process.

1
Ensure the vehicle is in the 'OFF' position and the keys are removed from the ignition.
2
Insert the key into the ignition (do not start the engine) or press the 'Start' button without pressing the brake to turn on the accessory mode.
3
Locate the gas pedal and ensure it is fully released.
4
Press the gas pedal three times within five seconds.
5
Turn the ignition to the 'ON' position (do not start the engine) while the gas pedal is pressed.
6
Observe the maintenance light; it should blink and then turn off, indicating a successful reset.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Ensure the vehicle is in the 'OFF' position and the keys are removed from the ignition.
2
Insert the key into the ignition (do not start the engine) or press the 'Start' button without pressing the brake to turn on the accessory mode.
3
Locate the gas pedal and ensure it is fully released.
4
Press the gas pedal three times within five seconds.
5
Turn the ignition to the 'ON' position (do not start the engine) while the gas pedal is pressed.
6
Observe the maintenance light; it should blink and then turn off, indicating a successful reset.

Solution

1. Preparation

2. Reset the Maintenance Light

Insert the key into the ignition or press the "Start" button to enter accessory mode.
Fully release the gas pedal.
Press the gas pedal three times within five seconds.
Turn the ignition to the "ON" position without starting the engine while keeping the gas pedal pressed.
Watch for the maintenance light to blink; it will turn off once the reset is successful.