how to fix the P0135 code on my Toyota Camry Seventh Generation (2012-2017)

Toyota Camry Seventh Generation (2012-2017)

Error Codes

1-2 hours

Time

medium

Difficulty

medium

Severity

Error Code: P0135

3 min read

486 words

Problem Statement

Learn how to diagnose and fix P0135 oxygen sensor heater circuit issues in a 2012-2017 Toyota Camry. Step-by-step guide with tools and tips.

Error Code

P0135

Affected Component

Exhaust System

Estimated Time

1-2 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical systems.
•Allow the engine to cool before working on exhaust components.

Symptoms

•Check engine light illuminated
•Decreased fuel efficiency
•Rough idle or poor engine performance
•Increased emissions during emissions testing
•Engine stalling or hesitation during acceleration

Diagnostic Steps

1
Scan for error codes using an OBD-II scanner to confirm P0135 and check for any related codes.
2
Inspect the wiring and connectors of the upstream oxygen sensor for damage or corrosion.
3
Check the heater circuit of the oxygen sensor using a multimeter to measure resistance.
4
Verify the vehicle’s battery voltage and ground connections.
5
Inspect the fuse related to the oxygen sensor heater circuit.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Multimeter
•Oxygen sensor socket
•Ratchet and socket set
•Torque wrench
•Wire strippers

Parts Required

•New upstream oxygen sensor
•Electrical wire (if needed)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Scan for error codes using an OBD-II scanner to confirm P0135 and check for any related codes.
2
Inspect the wiring and connectors of the upstream oxygen sensor for damage or corrosion.
3
Check the heater circuit of the oxygen sensor using a multimeter to measure resistance.
4
Verify the vehicle’s battery voltage and ground connections.
5
Inspect the fuse related to the oxygen sensor heater circuit.

Solution

1. Preparation

Gather necessary tools and parts.
Disconnect the battery to ensure safety during repairs.

2. Inspect and Repair Wiring

Tools Required: Multimeter, wire strippers, electrical tape
Inspect the wiring harness and connectors for any damage, fraying, or corrosion.
If any damage is found, use wire strippers to cut and strip the damaged section, then splice in a new wire. Secure with electrical tape.

3. Test and Replace Oxygen Sensor

Tools Required: Oxygen sensor socket, ratchet, torque wrench
Disconnect the oxygen sensor connector.
Use an oxygen sensor socket to remove the faulty sensor from the exhaust manifold.
Install the new oxygen sensor by threading it into the manifold and tightening it to the manufacturer's specified torque (typically around 30 ft-lbs).
Reconnect the oxygen sensor connector.

4. Reconnect Battery and Clear Codes

Reconnect the vehicle's battery.
Use the OBD-II scanner to clear the P0135 code from the ECU.

5. Final Checks

Start the engine and allow it to reach normal operating temperature.
Monitor the operation of the new oxygen sensor with the scanner for proper voltage readings.