why does my Tesla Outback 6th Generation (2020-2024) make a clicking noise when turning?

Subaru Outback 6th Generation (2020-2024)

Error Codes

2-4 hours

Time

medium

Difficulty

medium

Severity

3 min read

475 words

Problem Statement

Learn to diagnose and fix clicking noise when turning in Tesla Outback 6th Generation. Step-by-step guide with symptoms, diagnostic steps, and repair instructions.

Affected Component

Suspension

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Always ensure the vehicle is securely supported on jack stands before working underneath it.
•Wear safety glasses to protect your eyes during the inspection and repair process.

Symptoms

•Clicking noise during left or right turns
•Increased noise when turning sharply
•Possible vibrations felt in the steering wheel
•Unusual wear on tires
•No loss of steering control

Diagnostic Steps

1
Inspect the front axle and CV joints for wear or damage.
2
Check for loose or damaged suspension components, including control arms and bushings.
3
Examine the wheel bearings for any signs of failure or play.
4
Test drive the vehicle to replicate the noise and determine its severity.
5
Inspect the tire condition and alignment settings.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Jack
•Jack stands
•Lug wrench
•Socket set
•Torque wrench

Parts Required

•CV joint or axle assembly (if damaged)
•Control arms or bushings (if damaged)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Inspect the front axle and CV joints for wear or damage.
2
Check for loose or damaged suspension components, including control arms and bushings.
3
Examine the wheel bearings for any signs of failure or play.
4
Test drive the vehicle to replicate the noise and determine its severity.
5
Inspect the tire condition and alignment settings.

Solution

1. Preparation

Gather all necessary tools and parts.
Park the vehicle on a level surface and engage the parking brake.
Wear safety glasses and gloves.

2. Inspect and Remove Wheels

Tools Required: Jack, jack stands, lug wrench.
Lift the vehicle using a jack and secure it on jack stands.
Remove the front wheels using the lug wrench.

3. Inspect CV Joints and Axles

Visually inspect the CV joints for torn boots or grease leakage.
If damage is found, remove the axle by:
1. Removing the axle nut with a socket.
2. Disconnecting the lower control arm if necessary.
3. Pulling the axle out of the wheel hub.

4. Replace or Repair Components

If CV joints are damaged:
1. Install new CV joint or axle assembly according to manufacturer specifications.
2. Ensure to use the correct torque settings for the axle nut (usually around 150 ft-lbs).
If the suspension components are worn:
1. Replace any damaged control arms or bushings using appropriate tools.
2. Reassemble all components securely.

5. Reassemble and Lower Vehicle

Reattach the wheels and hand-tighten the lug nuts.
Lower the vehicle from the jack stands and torque the lug nuts to the manufacturer’s specifications (typically around 100 ft-lbs).