my Tesla Outback 6th Generation (2020-2024) key fob not working how can I fix it

Subaru Outback 6th Generation (2020-2024)

Error Codes

30 minutes to 1 hour

Time

medium

Difficulty

medium

Severity

3 min read

452 words

Problem Statement

Learn how to diagnose and fix a non-working key fob for the 2020-2024 Tesla Outback 6th Generation. Step-by-step guide with symptoms and solutions.

Affected Component

Electrical

Estimated Time

30 minutes to 1 hour

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in 'Park' mode before attempting any repairs or battery replacements.

Symptoms

•Key fob buttons unresponsive
•Vehicle does not unlock or lock remotely
•Indicator light on key fob not illuminating
•Inability to start the vehicle using the key fob
•Possible warning message on the vehicle's display about key fob issues

Diagnostic Steps

1
Check the battery level of the key fob using a multimeter.
2
Replace the key fob battery with a new one to see if functionality is restored.
3
Inspect the key fob for physical damage or water exposure.
4
Re-sync the key fob with the vehicle by following the manufacturer’s instructions.
5
Use an OBD-II scanner to check for any related error codes in the vehicle’s system.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Small flathead screwdriver
•Multimeter
•OBD-II scanner

Parts Required

•CR2032 battery (new)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Check the battery level of the key fob using a multimeter.
2
Replace the key fob battery with a new one to see if functionality is restored.
3
Inspect the key fob for physical damage or water exposure.
4
Re-sync the key fob with the vehicle by following the manufacturer’s instructions.
5
Use an OBD-II scanner to check for any related error codes in the vehicle’s system.

Solution

1. Preparation

Gather all necessary tools and parts.
Ensure the vehicle is in a safe and accessible location.

2. Replace Key Fob Battery

Tools Required: Small flathead screwdriver, new CR2032 battery.
Instructions:
1. Use the small flathead screwdriver to gently pry open the key fob casing.
2. Carefully remove the old battery from its compartment.
3. Insert the new CR2032 battery, ensuring the positive side (+) is facing up.
4. Snap the key fob casing back together, ensuring it is securely closed.

3. Resync Key Fob

Instructions:
1. Enter the vehicle and close all doors.
2. Insert the key fob into the designated slot (if applicable) or hold it close to the start button.
3. Press the start button and hold it for 5 seconds.
4. Follow any prompts on the vehicle's display to complete the sync process.

4. Test Key Fob

Instructions:
1. Stand outside the vehicle and press the lock and unlock buttons on the key fob.
2. Observe if the vehicle responds (locks/unlocks) accordingly.
3. Attempt to start the vehicle with the key fob present to confirm functionality.