why does my Tesla Outback 5th Generation (2015-2019) check engine light come on after oil change

Subaru Outback 5th Generation (2015-2019)

Error Codes

1-2 hours

Time

medium

Difficulty

medium

Severity

3 min read

512 words

Problem Statement

Discover why your Tesla Outback's check engine light comes on after an oil change. Follow our diagnostic steps and solutions to resolve the issue.

Affected Component

Engine

Estimated Time

1-2 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical systems.
•Allow the engine to cool before performing any maintenance tasks.

Symptoms

•Check engine light illuminated
•Possible engine misfire or rough running
•Increased engine noise
•Reduced fuel efficiency
•Oil leak or burning oil smell

Diagnostic Steps

1
Scan the vehicle's OBD-II system for error codes using a diagnostic scanner.
2
Inspect the oil level and condition to ensure the correct amount and type of oil was used.
3
Check for any oil leaks around the oil filter or drain plug.
4
Verify that the oil filter was properly installed and is not clogged.
5
Examine the engine for any loose or disconnected electrical connections during the oil change.
6
Inspect the air intake system and mass airflow sensor for any disturbances.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Oil filter wrench
•Multimeter
•Dipstick
•Funnel

Parts Required

•Engine oil (specification as per manufacturer)
•Oil filter (if replacement is needed)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Scan the vehicle's OBD-II system for error codes using a diagnostic scanner.
2
Inspect the oil level and condition to ensure the correct amount and type of oil was used.
3
Check for any oil leaks around the oil filter or drain plug.
4
Verify that the oil filter was properly installed and is not clogged.
5
Examine the engine for any loose or disconnected electrical connections during the oil change.
6
Inspect the air intake system and mass airflow sensor for any disturbances.

Solution

1. Preparation

Gather necessary tools and parts.
Disconnect the battery to prevent any electrical issues while working on the vehicle.
Ensure the vehicle is parked on a level surface and the engine is off.

2. Inspect and Correct Oil Level

Tools Required: Dipstick, funnel
Remove the dipstick, wipe it clean, and reinsert it to check the oil level.
If low, add the specified oil type slowly using a funnel until it reaches the appropriate level.

3. Check Oil Filter Installation

Tools Required: Oil filter wrench
Inspect the oil filter for proper installation.
If loose, tighten it according to the manufacturer's specifications.
If damaged or clogged, replace the oil filter with a new one.

4. Address Electrical Connections

Tools Required: Wire brush, multimeter
Visually inspect electrical connectors around the engine and oil change area.
Clean any corroded connectors with a wire brush and use a multimeter to check for continuity.

5. Clear Error Codes

Tools Required: OBD-II scanner
After resolving any issues, reconnect the battery and use the OBD-II scanner to clear any stored error codes.
Verify that the check engine light goes off.