my Tesla Outback 5th Generation (2015-2019) remote key fob is not working, how to fix?

Subaru Outback 5th Generation (2015-2019)

Error Codes

30 minutes

Time

easy

Difficulty

medium

Severity

3 min read

457 words

Problem Statement

Learn how to fix a non-working key fob for Tesla Outback 5th Generation (2015-2019). Step-by-step guide with diagnostic steps and repair instructions.

Affected Component

Electrical

Estimated Time

30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Be cautious when using tools to avoid injury or damage to the key fob.

Symptoms

•Key fob buttons unresponsive
•Vehicle does not unlock or lock when fob is pressed
•Indicator light on fob does not illuminate
•Range of the remote operation is significantly reduced
•Difficulty starting the vehicle using the key fob

Diagnostic Steps

1
Replace the battery in the key fob and test functionality.
2
Inspect the key fob for physical damage or water exposure.
3
Check for interference from other electronic devices nearby.
4
Verify that the vehicle is in range of the key fob.
5
Reset the key fob's connection with the vehicle if applicable.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Small flathead screwdriver
•New battery (CR2032)
•Soft cloth

Parts Required

•Key fob battery (CR2032)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather tools: Small flathead screwdriver, new battery (CR2032), and a soft cloth.
Ensure the vehicle is parked in a safe and accessible location.

2. Open the Key Fob

Using the small flathead screwdriver, gently pry open the key fob casing at the designated notch.
Be cautious to avoid damaging the casing or internal components.

3. Replace the Battery

Remove the old battery from the key fob, noting its orientation (positive side up).
Insert the new CR2032 battery in the same orientation as the old one.
Ensure it is seated properly in the battery compartment.

4. Reassemble the Key Fob

Align the two halves of the key fob and snap them back together securely.
Test the indicator light to confirm it illuminates upon button press.

5. Reprogram the Key Fob (if necessary)

Sit in the driver's seat and close all doors.
Insert the key into the ignition and turn to the "ON" position without starting the engine.
Press the lock button on the key fob for a few seconds, then turn the key to "OFF" and remove it.
Test the key fob to ensure it operates correctly.