how to troubleshoot key fob issues with Tesla Outback 5th Generation (2015-2019)

Subaru Outback 5th Generation (2015-2019)

Error Codes

30 minutes to 1 hour

Time

medium

Difficulty

medium

Severity

3 min read

445 words

Problem Statement

Learn how to troubleshoot key fob issues for Tesla Outback 5th Generation (2015-2019). Step-by-step guide with diagnostic steps and repair instructions.

Affected Component

Electrical

Estimated Time

30 minutes to 1 hour

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is off before working on the key fob.

Symptoms

•Key fob not responding when buttons are pressed
•Vehicle doors not unlocking or locking
•Warning message on the dashboard regarding the key fob
•Inability to start the vehicle
•Reduced range of the key fob's functionality

Diagnostic Steps

1
Check the battery level of the key fob using a multimeter.
2
Replace the key fob battery and test the functionality.
3
Inspect the key fob for physical damage or water intrusion.
4
Verify that the vehicle is within range of the key fob.
5
Re-sync the key fob with the vehicle's system using the vehicle's settings.
6
Scan the vehicle's onboard diagnostics for any error codes related to the keyless entry system.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Small flathead screwdriver
•Multimeter

Parts Required

•CR2032 key fob battery

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Check the battery level of the key fob using a multimeter.
2
Replace the key fob battery and test the functionality.
3
Inspect the key fob for physical damage or water intrusion.
4
Verify that the vehicle is within range of the key fob.
5
Re-sync the key fob with the vehicle's system using the vehicle's settings.
6
Scan the vehicle's onboard diagnostics for any error codes related to the keyless entry system.

Solution

1. Preparation

Gather necessary tools: small flathead screwdriver, new key fob battery (CR2032), multimeter.
Ensure the vehicle is turned off and in a safe location.

2. Replace the Key Fob Battery

Use a small flathead screwdriver to gently pry open the key fob casing.
Remove the old battery and note the orientation (positive side up).
Insert a new CR2032 battery in the same orientation.
Snap the key fob casing back together, ensuring it is securely closed.

3. Test Key Fob Functionality

Stand close to the vehicle and press the unlock button on the key fob.
Observe if the vehicle responds by unlocking the doors or activating the keyless start.
If it does not work, proceed to re-sync the key fob.

4. Re-sync the Key Fob

Enter the vehicle and close all doors.
Turn on the ignition (without starting the engine).
Press and hold the lock button on the key fob for 5 seconds.
Turn off the ignition and test the key fob again.