how to reset the check engine light on Tesla Outback 5th Generation (2015-2019)

Subaru Outback 5th Generation (2015-2019)

Error Codes

30 minutes

Time

easy

Difficulty

medium

Severity

3 min read

419 words

Problem Statement

Learn how to reset the check engine light on a 2015-2019 Subaru Outback. Step-by-step guide with diagnostic procedures and tools required.

Affected Component

Engine

Estimated Time

30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in a safe parking area before performing any diagnostics or repairs

Symptoms

•Check engine light illuminated
•Error codes stored in the engine control module (ECM)
•Dashboard warning messages displayed
•Potential for rough engine idle or performance issues if related to a fault

Diagnostic Steps

1
Scan for error codes using OBD-II scanner
2
Address underlying issues that caused the check engine light to illuminate
3
Clear error codes using the OBD-II scanner

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Vehicle owner's manual

Parts Required

•None required specifically for resetting the check engine light.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Tools Required: OBD-II scanner, vehicle owner's manual for reference.
Ensure the vehicle is parked on a level surface and the engine is off.

2. Connect OBD-II Scanner

Locate the OBD-II port under the dashboard on the driver's side.
Plug the OBD-II scanner into the port.
Turn the vehicle ignition to the "On" position without starting the engine.

3. Access Engine Codes

Follow the instructions on the OBD-II scanner to access the engine codes stored in the ECM.
Note any codes for future reference.

4. Clear Codes

Select the option to clear or erase codes on the OBD-II scanner.
Confirm the action when prompted.
Wait for the scanner to indicate that the codes have been successfully cleared.

5. Disconnect the OBD-II Scanner

Safely unplug the OBD-II scanner from the port.
Turn off the vehicle ignition.

6. Test Drive

Start the vehicle and take it for a short test drive.
Monitor the dashboard to ensure the check engine light remains off.