how to fix Tesla Outback 5th Generation (2015-2019) rear camera not functioning

Subaru Outback 5th Generation (2015-2019)

Error Codes

2-4 hours

Time

medium

Difficulty

medium

Severity

3 min read

496 words

Problem Statement

Learn how to diagnose and fix the rear camera not functioning issue in Tesla Outback (2015-2019). Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Electrical

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect battery before working on electrical systems to prevent shock or short circuits.

Symptoms

•Rear camera display is blank or shows a distorted image
•No guidance lines appear on the display
•Check for any error messages related to the camera system
•Rearview camera takes an unusually long time to activate
•Backup assist features (if applicable) are unresponsive

Diagnostic Steps

1
Scan for error codes using an OBD-II scanner to identify any faults in the camera system.
2
Inspect the rear camera wiring harness for visible damage or loose connections.
3
Check the vehicle's software version and update to the latest firmware if necessary.
4
Test the rear camera’s power supply using a multimeter to ensure it is receiving voltage.
5
Verify the display settings on the infotainment system to ensure the camera is activated.
6
Perform a reset of the infotainment system to clear any temporary glitches.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Multimeter
•Screwdriver set
•Trim removal tools

Parts Required

•Replacement rear camera (if faulty)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Scan for error codes using an OBD-II scanner to identify any faults in the camera system.
2
Inspect the rear camera wiring harness for visible damage or loose connections.
3
Check the vehicle's software version and update to the latest firmware if necessary.
4
Test the rear camera’s power supply using a multimeter to ensure it is receiving voltage.
5
Verify the display settings on the infotainment system to ensure the camera is activated.
6
Perform a reset of the infotainment system to clear any temporary glitches.

Solution

1. Preparation

Gather necessary tools and parts.
Ensure the vehicle is parked on a flat surface and turned off.
Disconnect the vehicle's battery to avoid electrical shock.

2. Inspect Wiring and Connections

Remove the rear trim panel to access the camera wiring harness.
Check all connectors for corrosion or loose connections; reseat any loose connectors.
Use a multimeter to check continuity in the wiring from the camera to the infotainment system.

3. Replace the Rear Camera (if necessary)

If the wiring and connections are intact, remove the rear camera by unscrewing it from its mounting bracket.
Disconnect the wiring harness from the camera.
Install the new camera by reversing the removal steps: connect the wiring harness and secure it with screws.
Ensure the camera is properly aligned and seated in its bracket.

4. Reconnect Battery and Test

Reconnect the vehicle's battery.
Turn on the vehicle and check the infotainment system for camera operation.
Engage the reverse gear to see if the camera displays correctly.