how to check for a bad ignition coil in my Tesla Outback 5th Generation (2015-2019)?

Subaru Outback 5th Generation (2015-2019)

Error Codes

1-2 hours

Time

medium

Difficulty

high

Severity

3 min read

535 words

⚠️ Safety Warning

This issue requires immediate attention. If you are not experienced with automotive repairs, consult a professional mechanic. Working on critical systems can be dangerous.

Problem Statement

Learn how to diagnose and fix ignition coil issues in Tesla Outback 5th Generation (2015-2019). Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Engine

Estimated Time

1-2 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect battery before working on electrical systems
•Allow engine to cool before touching components to avoid burns

Symptoms

•Engine misfires or rough running
•Decreased fuel efficiency
•Check engine light illuminated
•Difficulty starting the engine
•Increased emissions
•Engine stalling or hesitation during acceleration

Diagnostic Steps

1
Scan for error codes using OBD-II scanner
2
Inspect ignition coil visually for damage
3
Check spark plug condition for wear or damage
4
Test coil resistance with a multimeter
5
Perform a coil swap test if multiple coils are present
6
Check for power supply to the ignition coil

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Multimeter
•Socket set
•Torque wrench

Parts Required

•Ignition coil (if faulty)
•Spark plugs (if damaged)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather all necessary tools and parts. Disconnect the battery to ensure safety.
Tools Required: OBD-II scanner, multimeter, socket set, torque wrench.

2. Remove Ignition Coil

Locate the ignition coil(s) on the engine.
Using a socket set, remove the bolts securing the ignition coil to the engine.
Disconnect the electrical connector from the ignition coil by carefully releasing the locking tab.

3. Inspect and Test the Ignition Coil

Visual Inspection: Check for cracks or signs of wear.
Resistance Testing: Set the multimeter to the ohm setting. Measure the primary and secondary resistance as per specifications. If the readings are outside the normal range, the coil is faulty.
Coil Swap Test (if applicable): Install a known good ignition coil in place of the suspected faulty one and reassemble temporarily to test.

4. Reinstall Ignition Coil

If the coil is functioning properly, reinstall it by reversing the removal process.
Connect the electrical connector until it clicks and secure it with bolts to the specified torque value.

5. Final Check

Reconnect the battery and clear any error codes using the OBD-II scanner.
Start the engine and observe for normal operation.