how to reset the oil light in Tesla Outback 4th Generation (2010-2014)

Subaru Outback 4th Generation (2010-2014)

10-15 minutes

Time

easy

Difficulty

low

Severity

2 min read

324 words

Problem Statement

Learn how to reset the oil light in a Subaru Outback (2010-2014) after an oil change. Step-by-step guide with diagnostic steps and safety tips.

Affected Component

Engine

Estimated Time

10-15 minutes

Important safety information - read before proceeding

•Ensure the vehicle is in park or neutral and on a flat surface to prevent unintended movement.

1
Verify that the oil change was performed and the new oil is filled to the proper level.
2
Turn the ignition to the 'ON' position without starting the engine.
3
Check if the oil light remains illuminated during the pre-start checks.
4
Inspect the vehicle's manual for specific reset instructions, if available.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Verify that the oil change was performed and the new oil is filled to the proper level.
2
Turn the ignition to the 'ON' position without starting the engine.
3
Check if the oil light remains illuminated during the pre-start checks.
4
Inspect the vehicle's manual for specific reset instructions, if available.

Solution

1. Preparation

2. Reset Oil Light

Insert the key fob or turn the ignition key to the "ON" position (do not start the engine).
Press the gas pedal three times within 10 seconds.
Turn the ignition off and then back to the "ON" position.
Confirm that the oil light has been reset by verifying that it is no longer illuminated.