how to reset the oil change light on Tesla Outback 4th Generation (2010-2014)

Subaru Outback 4th Generation (2010-2014)

Error Codes

5-10 minutes

Time

easy

Difficulty

low

Severity

2 min read

338 words

Problem Statement

Learn how to reset the oil change light on a 2010-2014 Subaru Outback. Step-by-step guide to clear the maintenance reminder after an oil change.

Affected Component

Electrical

Estimated Time

5-10 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in park (for automatic transmission) or neutral (for manual transmission) before resetting the oil change light.

Symptoms

•Oil change light illuminated on the dashboard
•Maintenance reminder message displayed
•Oil change indicator showing due or overdue status

Diagnostic Steps

1
Turn the ignition switch to the 'ON' position without starting the engine.
2
Press the gas pedal three times in succession within 10 seconds.
3
Observe the oil change light; it should begin to blink and then turn off.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•None required

Parts Required

•None required

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Ensure the vehicle is parked on a level surface and the ignition is off.
Gather necessary tools: None required for this reset process.

2. Access the Ignition

Insert the key into the ignition or ensure the key fob is in the vehicle.
Turn the ignition switch to the “ON” position (do not start the engine).

3. Reset the Oil Change Light

Quickly press the gas pedal three times within a span of 10 seconds.
Watch for the oil change light to blink; this indicates the reset process is in progress.
The light should turn off completely if the reset was successful.

4. Confirm the Reset

Turn the ignition off and then back on to verify that the oil change light is no longer illuminated.