how to reset the infotainment system on Tesla Outback 4th Generation (2010-2014)

Subaru Outback 4th Generation (2010-2014)

Error Codes

15-30 minutes for soft reset; up to 1 hour for hard reset

Time

easy

Difficulty

medium

Severity

3 min read

497 words

Problem Statement

Learn how to reset the infotainment system on 2010-2014 Subaru Outback. Step-by-step guide for troubleshooting and restoring functionality.

Affected Component

Electrical

Estimated Time

15-30 minutes for soft reset; up to 1 hour for hard reset

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in park and on a level surface before performing resets.
•Take precautions when working with the battery; avoid touching the positive and negative terminals simultaneously.

Symptoms

•Infotainment system screen is frozen or unresponsive
•Audio system not functioning or producing no sound
•Navigation system displaying incorrect information or not loading
•Bluetooth connectivity issues
•System slow to respond to inputs

Diagnostic Steps

1
Verify that the vehicle is in a safe and stationary position.
2
Check the vehicle's battery voltage to ensure it is sufficient (above 12.4V).
3
Inspect the infotainment system for physical damage or loose connections.
4
Attempt a simple power cycle by turning the vehicle off and then back on.
5
Review the owner’s manual for specific reset instructions related to the infotainment system.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•None required for soft reset
•Socket wrench for battery disconnect (if performing hard reset)

Parts Required

•None required.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Verify that the vehicle is in a safe and stationary position.
2
Check the vehicle's battery voltage to ensure it is sufficient (above 12.4V).
3
Inspect the infotainment system for physical damage or loose connections.
4
Attempt a simple power cycle by turning the vehicle off and then back on.
5
Review the owner’s manual for specific reset instructions related to the infotainment system.

Solution

1. Preparation

Ensure the vehicle is parked safely with the engine turned off.
Gather necessary tools: none required for this reset.

2. Perform a Soft Reset

Locate the Power Button: Identify the power button on the infotainment system.
Press and Hold: Press and hold the power button for approximately 10 seconds until the screen goes blank.
Release: Release the power button and wait for the system to reboot. The Subaru logo should appear on the screen, indicating that the system is restarting.
Test Functionality: Once the system has rebooted, check the responsiveness of the infotainment features like audio, navigation, and connectivity.

3. Perform a Hard Reset (if necessary)

Disconnect the Battery: If the soft reset does not resolve the issue, disconnect the negative terminal of the vehicle's battery.
- Use a socket wrench to loosen the bolt on the negative terminal and carefully remove the cable.
Wait: Allow the battery to remain disconnected for at least 10 minutes to ensure all electronic systems reset.
Reconnect the Battery: Reconnect the negative terminal securely and tighten the bolt.
Start the Vehicle: Turn the ignition to the ON position and start the vehicle. Allow the infotainment system to boot up and check its functionality.