how to fix P0011 timing issue in Tesla Outback 4th Generation (2010-2014)

Solution

1. Preparation

• Gather all necessary tools and parts.
• Disconnect the vehicle's negative battery terminal to prevent electrical shorts during repair.
• Allow the engine to cool before working on it.

2. Replace VVT Solenoid

1. Locate the VVT Solenoid:
   • Refer to the service manual for the specific location on the engine.
2. Remove the Old Solenoid:
   • Disconnect the electrical connector from the VVT solenoid.
   • Remove the mounting bolts using a socket set.
   • Carefully pull the solenoid out of the engine.
3. Install New Solenoid:
   • Apply a small amount of engine oil to the O-ring of the new solenoid.
   • Insert the new solenoid into its housing and secure it with mounting bolts to the specified torque (typically around 8-10 ft-lbs).
   • Reconnect the electrical connector.

3. Change Engine Oil and Filter

1. Drain Old Oil:
   • Place a drain pan under the oil pan and remove the drain plug.
   • Allow the oil to fully drain.
2. Replace Oil Filter:
   • Use an oil filter wrench to remove the old oil filter.
   • Apply a thin layer of oil to the rubber gasket of the new filter.
   • Install the new oil filter by hand; do not overtighten.
3. Refill Engine Oil:
   • Replace the drain plug and torque it to specifications (usually 30-35 ft-lbs).
   • Fill the engine with the recommended oil type and quantity (check the owner's manual for specifications).

4. Clear Codes and Test Drive

1. Reconnect Battery:
   • Reattach the negative battery terminal and tighten it securely.
2. Clear Engine Codes:
   • Use the OBD-II scanner to clear the P0011 code from the system.
3. Test Drive:
   • Drive the vehicle under various conditions to ensure the issue is resolved and monitor for any reoccurrence of the check engine light.