how do I reset the check engine light on my Tesla Outback 4th Generation (2010-2014)?

Subaru Outback 4th Generation (2010-2014)

15-30 minutes

Time

easy

Difficulty

medium

Severity

3 min read

410 words

Problem Statement

Learn how to reset the check engine light on your Tesla Outback 4th Generation (2010-2014) with this step-by-step guide and diagnostic procedures.

Affected Component

Electrical

Estimated Time

15-30 minutes

Important safety information - read before proceeding

1
Use an OBD-II scanner to read any error codes stored in the vehicle's computer.
2
Address any underlying issues indicated by the error codes before attempting to reset the light.
3
Locate the OBD-II port, typically found under the dashboard near the steering column.
4
Plug the OBD-II scanner into the port and turn on the vehicle's ignition to the 'On' position without starting the engine.
5
Follow the scanner’s prompts to clear the error codes and reset the check engine light.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Use an OBD-II scanner to read any error codes stored in the vehicle's computer.
2
Address any underlying issues indicated by the error codes before attempting to reset the light.
3
Locate the OBD-II port, typically found under the dashboard near the steering column.
4
Plug the OBD-II scanner into the port and turn on the vehicle's ignition to the 'On' position without starting the engine.
5
Follow the scanner’s prompts to clear the error codes and reset the check engine light.

Solution

1. Preparation

2. Using the OBD-II Scanner

Connect the OBD-II Scanner:
- Locate the OBD-II port under the dashboard.
- Plug the scanner into the port securely.
Turn on the Ignition:
- Without starting the engine, turn the key to the "On" position to power the vehicle’s electronics.
Access the Scanner Menu:
- Follow the manufacturer’s instructions to navigate to the “Read Codes” or “Diagnostic” section.
Clear Error Codes:
- Select the option to “Erase Codes” or “Clear DTCs”.
- Confirm the action when prompted.
Disconnect the Scanner:
- Remove the scanner from the OBD-II port.
- Turn off the vehicle's ignition.