my Ram 1500 DT (2019-Present) feels like it's slipping when accelerating, what to do?

Solution

1. Preparation

• Tools Required: OBD-II scanner, transmission fluid, funnel, basic socket set, torque wrench, transmission filter kit.
• Ensure the vehicle is on a flat surface and secured with wheel chocks.
• Disconnect the battery to prevent electrical shorts.

2. Check and Replace Transmission Fluid

• Sub-steps:
  1. Locate the transmission dipstick and remove it.
  2. Check the fluid level; if low, add the manufacturer-recommended transmission fluid.
  3. If the fluid is dark or has a burnt smell, proceed to drain the fluid.
  4. Place a drain pan underneath the transmission pan, remove the pan bolts, and carefully lower the pan.
  5. Replace the transmission filter according to the kit instructions.
  6. Reinstall the pan, ensuring a proper gasket seal.
  7. Fill the transmission with new fluid through the dipstick tube using a funnel.

3. Inspect and Replace Torque Converter (if necessary)

• Sub-steps:
  1. Raise the vehicle securely on jack stands and remove the drive shaft if needed.
  2. Unbolt the torque converter from the flexplate.
  3. Remove the transmission from the vehicle following standard procedures.
  4. Inspect the torque converter for any visible damage or wear.
  5. If necessary, replace it with a new torque converter, ensuring proper alignment during installation.
  6. Reassemble the transmission and driveshaft, following torque specifications for all bolts.

4. Reconnect Battery and Test

• Reconnect the battery terminals and ensure all connections are secure.
• Start the engine and allow it to reach operating temperature.
• Test drive the vehicle to verify that the slipping sensation is resolved.