my Ram 1500 DT (2019-Present) check engine light won’t go off, how to reset?

Ram 1500 DT (2019-Present)

Error Codes

30 minutes to 1 hour

Time

medium

Difficulty

medium

Severity

3 min read

425 words

Problem Statement

Learn how to reset the check engine light on your Ram 1500 DT (2019-Present). Step-by-step guide with diagnostic steps and solutions.

Affected Component

Engine

Estimated Time

30 minutes to 1 hour

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in park and the engine is off before connecting or disconnecting the battery

Symptoms

•Check engine light illuminated
•Vehicle may experience reduced engine performance
•Possible changes in fuel economy
•Engine may run rough or idle irregularly
•No audible alerts or messages displayed on the dashboard

Diagnostic Steps

1
Use an OBD-II scanner to check for diagnostic trouble codes (DTCs)
2
Record any codes found and clear them using the scanner
3
Turn the vehicle off and then restart to see if the light returns
4
Inspect for any visible issues under the hood such as loose connections or damaged wires
5
Check fluid levels and inspect for any leaks that might trigger the check engine light

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Wrench set

Parts Required

•None specifically for the reset; however, codes may indicate parts needing replacement.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Use an OBD-II scanner to check for diagnostic trouble codes (DTCs)
2
Record any codes found and clear them using the scanner
3
Turn the vehicle off and then restart to see if the light returns
4
Inspect for any visible issues under the hood such as loose connections or damaged wires
5
Check fluid levels and inspect for any leaks that might trigger the check engine light

Solution

1. Preparation

Gather necessary tools and materials.
Ensure the vehicle is parked on a level surface, and the engine is turned off.
Disconnect the negative battery terminal to reset the ECU (Engine Control Unit).

2. Scan and Clear Codes

Connect the OBD-II scanner to the vehicle's diagnostic port.
Turn the ignition to the "On" position without starting the engine.
Navigate through the scanner menu to retrieve stored codes.
Record any codes for reference.
Select the option to clear or reset the codes.
Wait for the scanner to confirm that the codes have been cleared.

3. Reconnect Battery

Reconnect the negative battery terminal securely.
Ensure all connections are tight, and the terminal is properly fitted.

4. Test Drive

Start the engine and allow it to idle for a few minutes.
Check that the check engine light remains off.
Take the vehicle for a short test drive to monitor for any reoccurrence of the check engine light.