how to reset the check engine light on Ram 1500 DT (2019-Present)

Ram 1500 DT (2019-Present)

Error Codes

15-30 minutes

Time

medium

Difficulty

medium

Severity

3 min read

417 words

Problem Statement

Learn how to reset the check engine light on a 2019-present Ram 1500 DT. Step-by-step guide with diagnostic procedures and instructions.

Affected Component

Electrical

Estimated Time

15-30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is parked on a flat, stable surface before performing any work.

Symptoms

•Check engine light illuminated
•Engine running normally after repairs
•Diagnostic trouble codes (DTCs) stored in the ECU
•No other warning lights present

Diagnostic Steps

1
Use an OBD-II scanner to check for any diagnostic trouble codes.
2
Address and repair any underlying issues indicated by the trouble codes.
3
Clear the trouble codes using the OBD-II scanner.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner

Parts Required

•None (assuming underlying issue has already been addressed)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather necessary tools including an OBD-II scanner and ensure the vehicle is parked on a level surface.
Turn off the ignition and make sure the vehicle is in park (automatic) or neutral (manual).

2. Connect OBD-II Scanner

Locate the OBD-II port under the dashboard near the driver's seat.
Plug in the OBD-II scanner and turn on the vehicle's ignition without starting the engine (to the "on" position).

3. Read Diagnostic Trouble Codes

Follow the scanner's prompts to read any stored diagnostic trouble codes.
Note down any codes for reference in case further repairs are needed.

4. Clear the Check Engine Light

On the scanner, navigate to the option for clearing codes or resetting the check engine light.
Select the option and confirm the action to erase the trouble codes from the ECU.

5. Disconnect OBD-II Scanner

Once codes are cleared, safely disconnect the OBD-II scanner from the port.
Turn off the ignition.

6. Test the Vehicle

Start the vehicle and check if the check engine light remains off.
Allow the engine to run for a few minutes to verify that the light does not re-illuminate.