how to reset the check engine light on my Ram 1500 DT (2019-Present)?

Ram 1500 DT (2019-Present)

Error Codes

15-30 minutes

Time

easy

Difficulty

medium

Severity

3 min read

444 words

Problem Statement

Learn how to reset the check engine light on your 2019-Present Ram 1500 DT. Follow our step-by-step guide for a quick and easy solution.

Affected Component

Electrical

Estimated Time

15-30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in park or neutral and on a level surface before working with the OBD-II system.

Symptoms

•Check engine light illuminated on the dashboard
•Possible error codes stored in the vehicle's computer
•Engine running normally, or may be experiencing minor performance issues
•Reduced fuel efficiency (if related to a persistent problem)
•No other warning lights illuminated

Diagnostic Steps

1
Scan the vehicle's OBD-II system using an OBD-II scanner to check for error codes.
2
Note down any error codes that appear, and determine if they are related to a minor issue.
3
Address any underlying issues indicated by error codes before resetting the check engine light.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner

Parts Required

•None for the reset process, but any necessary repairs should be addressed.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Ensure the vehicle is parked in a well-ventilated area.
Gather necessary tools including an OBD-II scanner.
Turn off the ignition and ensure all electrical systems are off.

2. Connect OBD-II Scanner

Locate the OBD-II port under the dashboard near the driver's seat.
Plug the OBD-II scanner into the port.
Turn the ignition to the "On" position without starting the engine.

3. Read and Clear Codes

Follow the scanner's instructions to read the error codes stored in the Vehicle Control Module (VCM).
If codes indicate a temporary issue (like a loose gas cap), fix the issue.
Select the option to "Clear Codes" or "Erase Codes" on the OBD-II scanner.
Confirm the action when prompted by the scanner.

4. Disconnect OBD-II Scanner

Once codes are cleared, turn off the ignition.
Carefully unplug the OBD-II scanner from the port.
Ensure all tools are removed from the vehicle.

5. Test Drive

Start the engine and monitor the dashboard for the check engine light.
Take the vehicle for a short drive to ensure the light remains off.