how to reset the check engine light on a Ram 1500 DT (2019-Present)

Ram 1500 DT (2019-Present)

Error Codes

30 minutes

Time

easy

Difficulty

medium

Severity

2 min read

387 words

Problem Statement

Learn how to reset the check engine light on a 2019-present Ram 1500 DT. Step-by-step guide with diagnostic procedures and reset instructions.

Affected Component

Electrical

Estimated Time

30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in a safe and stable position before working on the electrical systems

Symptoms

•Check engine light illuminated
•No noticeable changes in engine performance
•Possible previous error codes stored in the vehicle's computer
•Engine runs smoothly after repairs

Diagnostic Steps

1
Scan for error codes using an OBD-II scanner
2
Address any underlying issues causing the check engine light to activate
3
Confirm that the vehicle's systems are functioning correctly before resetting the light

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner

Parts Required

•None (assuming underlying issues have already been addressed)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Ensure the vehicle is parked on a flat surface.
Turn off the ignition and remove the key.
Gather tools: OBD-II scanner.

2. Connect OBD-II Scanner

Locate the OBD-II port under the dashboard, near the driver's side.
Plug the OBD-II scanner into the port.

3. Turn on Ignition

Turn the vehicle's ignition to the "On" position without starting the engine.
Follow the prompts on the OBD-II scanner to connect to the vehicle's computer.

4. Reset Check Engine Light

Once connected, navigate to the "Erase Codes" or "Clear Codes" option on the scanner.
Confirm the selection to reset the check engine light.
Wait for the scanner to indicate that the codes have been successfully cleared.

5. Disconnect Scanner

After the reset, safely unplug the OBD-II scanner from the port.
Turn off the ignition.

6. Final Check

Start the engine and verify that the check engine light remains off.
Monitor for any reoccurrence of the issue over the next few days.