how to replace the transmission filter in my Ram 1500 DT (2019-Present)

Ram 1500 DT (2019-Present)

Error Codes

2-4 hours

Time

medium

Difficulty

medium

Severity

3 min read

541 words

Problem Statement

Step-by-step guide to replace the transmission filter in Ram 1500 DT (2019-Present). Learn symptoms, diagnostic steps, and required tools.

Affected Component

Transmission

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before starting work on electrical components.
•Allow the engine and transmission to cool before starting the procedure.

Symptoms

•Slipping or rough shifting
•Overheating transmission
•Transmission fluid contamination
•Check engine or transmission warning light illuminated
•Fluid leaks under the vehicle

Diagnostic Steps

1
Check the transmission fluid level and condition using the dipstick.
2
Scan for any transmission-related error codes using an OBD-II scanner.
3
Inspect for any visible leaks around the transmission pan and cooler lines.
4
Test drive the vehicle to assess shifting performance.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Socket set
•Torque wrench
•Transmission filter kit
•Pan gasket (if needed)
•Funnel
•Shop rags
•OBD-II scanner

Parts Required

•Transmission filter
•Transmission pan gasket (if needed)
•Transmission fluid (specific to the model)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Tools Required: Socket set, torque wrench, transmission filter kit, pan gasket (if needed), funnel, shop rags, OBD-II scanner.
Begin by parking the vehicle on a level surface and engaging the parking brake.
Gather necessary tools and parts.

2. Raise the Vehicle

Use a jack to lift the front of the vehicle and secure it with jack stands.
Ensure the vehicle is stable before proceeding.

3. Remove Transmission Pan

Sub-steps:
- Place a drain pan under the transmission pan to catch fluid.
- Remove the bolts securing the transmission pan using the socket set.
- Carefully lower the pan and allow any remaining fluid to drain completely.
Safety Warning: Transmission fluid can be hot, allow it to cool before handling.

4. Replace Transmission Filter

Sub-steps:
- Locate the transmission filter, which is typically secured with screws or clips.
- Remove the old filter and discard it. Ensure the O-ring from the old filter is not stuck in the transmission.
- Install the new transmission filter, ensuring it is seated properly and secure it with screws or clips.

5. Clean and Reinstall Transmission Pan

Sub-steps:
- Clean the mating surface of the transmission and the inside of the pan thoroughly to remove old gasket material.
- If necessary, replace the transmission pan gasket.
- Reinstall the transmission pan and torque the bolts to the manufacturer’s specifications (typically 8-10 ft-lbs).

6. Refill Transmission Fluid

Sub-steps:
- Using a funnel, add the appropriate type and amount of transmission fluid through the dipstick tube.
- Start the engine and allow it to reach operating temperature, cycling through all gears.
- Check the fluid level again and add more fluid if necessary.