my Honda Pilot YF3 (2016-2022) rear brakes squeak, what could be wrong?

Solution

1. Preparation

• Gather tools and safety equipment.
• Lift the rear of the vehicle using a jack and secure it on jack stands.
• Remove the rear wheels to access the brake assembly.

2. Inspect and Replace Brake Pads

1. Remove the caliper bolts using a socket set (typically 12mm or 14mm).
2. Carefully slide the caliper off the rotor; support it using a bungee cord to prevent strain on the brake line.
3. Remove the old brake pads from the caliper bracket.
4. Measure the thickness of the pads; replace if worn below specifications (usually 3mm).
5. Apply brake grease to the back of new pads to prevent noise.
6. Install new brake pads into the caliper bracket.

3. Inspect and Replace Brake Rotors (if necessary)

1. Check rotor thickness with a micrometer; replace if below minimum specifications.
2. If replacement is necessary, remove the caliper bracket by removing the bolts.
3. Slide the rotor off the hub; clean the hub surface with a wire brush.
4. Install new rotors, ensuring the surfaces are clean and free of oil.
5. Reattach the caliper bracket and torque bolts to manufacturer specifications (typically 80-100 ft-lbs).

4. Reassemble and Test

1. Reinstall the caliper over the new pads and torque the caliper bolts.
2. Reattach the wheels and lower the vehicle.
3. Pump the brake pedal several times to seat the pads against the rotors.
4. Test drive the vehicle at low speeds to check for noise and performance.