my Honda Pilot Third Generation (2016-present) remote start not working how to fix

Honda Pilot Third Generation (2016-present)

Error Codes

1-2 hours

Time

medium

Difficulty

medium

Severity

3 min read

474 words

Problem Statement

Learn how to diagnose and fix the remote start issue in a Honda Pilot Third Generation. Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Electrical

Estimated Time

1-2 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical systems to prevent shock or shorts.

Symptoms

•Remote start button does not respond when pressed
•Vehicle does not start or crank when using the remote
•Indicator lights do not flash upon pressing the remote start button
•Key fob battery indicator may show low battery
•Engine does not turn over after multiple attempts

Diagnostic Steps

1
Inspect the key fob battery for charge and replace if necessary.
2
Check for any visible damage to the key fob or wiring.
3
Scan the vehicle’s body control module for error codes using an OBD-II scanner.
4
Verify that the vehicle is in 'Park' and all doors are closed.
5
Test the remote start feature using a different key fob if available.
6
Examine the vehicle's security system for any issues that may disable remote start.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Small flathead screwdriver

Parts Required

•CR2032 battery

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Inspect the key fob battery for charge and replace if necessary.
2
Check for any visible damage to the key fob or wiring.
3
Scan the vehicle’s body control module for error codes using an OBD-II scanner.
4
Verify that the vehicle is in 'Park' and all doors are closed.
5
Test the remote start feature using a different key fob if available.
6
Examine the vehicle's security system for any issues that may disable remote start.

Solution

1. Preparation

Gather necessary tools and parts.
Ensure the vehicle is parked safely and the engine is off.
Disconnect the battery to prevent electrical shock or shorts.

2. Replace Key Fob Battery

Tools Required: Small flathead screwdriver, CR2032 battery (or as specified for the fob).
Open the key fob using the screwdriver to avoid damaging the casing.
Remove the old battery and replace it with a new one, ensuring the correct polarity is observed.
Reassemble the key fob and test the remote start feature.

3. Inspect and Reset the Remote Start System

Tools Required: OBD-II scanner.
Reconnect the battery and turn the ignition to the "ON" position without starting the engine.
Use the OBD-II scanner to check for any fault codes related to the remote start system.
Clear any codes found and attempt to use the remote start feature again.

4. Check the Security System

Tools Required: None specific.
Ensure that all doors are properly closed and the vehicle is in "Park."
If the security system is triggered, reset it by locking and unlocking the vehicle using the key fob.