how to reset the tire pressure sensor on Honda Pilot YF3 (2016-2022)

Honda Pilot Third Generation (2016-present)

Error Codes

15-30 minutes

Time

easy

Difficulty

medium

Severity

3 min read

404 words

Problem Statement

Learn how to reset the tire pressure sensor on Honda Pilot YF3 (2016-2022). Step-by-step instructions for accurate tire pressure monitoring.

Affected Component

Electrical

Estimated Time

15-30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is parked on a flat surface and the parking brake is engaged before performing any reset procedures.

Symptoms

•TPMS warning light illuminated on the dashboard
•Inaccurate tire pressure readings displayed
•Warning message displayed on the vehicle information screen
•Tire pressure sensor malfunction message (if applicable)

Diagnostic Steps

1
Verify that all tires are inflated to the recommended pressure as indicated on the driver’s door jamb.
2
Turn the ignition switch to the 'ON' position without starting the engine.
3
Locate the TPMS reset button, usually found beneath the steering column or on the dashboard.
4
Press and hold the TPMS reset button until the TPMS light blinks three times, then release it.
5
Start the engine and drive the vehicle at speeds above 30 mph for at least 10 minutes to allow the system to recalibrate.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•TPMS reset tool (if available)
•Tire pressure gauge

Parts Required

•None

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Verify that all tires are inflated to the recommended pressure as indicated on the driver’s door jamb.
2
Turn the ignition switch to the 'ON' position without starting the engine.
3
Locate the TPMS reset button, usually found beneath the steering column or on the dashboard.
4
Press and hold the TPMS reset button until the TPMS light blinks three times, then release it.
5
Start the engine and drive the vehicle at speeds above 30 mph for at least 10 minutes to allow the system to recalibrate.

Solution

1. Preparation

Gather necessary tools: TPMS reset tool (if available), tire pressure gauge.
Ensure all tires are properly inflated to the recommended PSI.

2. Locate TPMS Reset Button

Check the owner’s manual to confirm the exact location of the TPMS reset button.
Typically, it is located under the steering column or near the dashboard.

3. Reset TPMS

Turn the ignition to the "ON" position without starting the engine.
Press and hold the TPMS reset button until the TPMS light blinks three times, then release the button.

4. Calibration

Start the engine.
Drive the vehicle at a speed of 30 mph or higher for about 10 minutes. This allows the TPMS to recalibrate and recognize the correct tire pressures.