how to reset the maintenance light on Honda Pilot YF3 (2016-2022)?

Honda Pilot Third Generation (2016-present)

Error Codes

5-10 minutes

Time

easy

Difficulty

low

Severity

2 min read

360 words

Problem Statement

Learn how to reset the maintenance light on Honda Pilot YF3 (2016-2022) with this step-by-step guide. Quick and easy instructions for your vehicle.

Affected Component

Electrical

Estimated Time

5-10 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in 'Park' mode before performing the reset.

Symptoms

•Maintenance light illuminated on the dashboard
•Reminder for oil change or service displayed
•Inability to clear the warning through normal driving

Diagnostic Steps

1
Turn the ignition switch to the 'On' position without starting the engine.
2
Ensure that the odometer display is showing the total mileage, not trip A or trip B.
3
Press and hold the 'Select/Reset' button on the instrument panel.
4
While holding the 'Select/Reset' button, turn the ignition switch to the 'Off' position.
5
Continue holding the button and turn the ignition switch back to the 'On' position.
6
Release the 'Select/Reset' button when the maintenance light starts blinking and then goes off.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•None required for this procedure

Parts Required

•None required for this procedure

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Turn the ignition switch to the 'On' position without starting the engine.
2
Ensure that the odometer display is showing the total mileage, not trip A or trip B.
3
Press and hold the 'Select/Reset' button on the instrument panel.
4
While holding the 'Select/Reset' button, turn the ignition switch to the 'Off' position.
5
Continue holding the button and turn the ignition switch back to the 'On' position.
6
Release the 'Select/Reset' button when the maintenance light starts blinking and then goes off.

Solution

1. Preparation

Gather your tools and ensure the vehicle is parked on a level surface.
Ensure the vehicle is in the "Park" position for safety.

2. Ignition Check

Turn the ignition switch to the "On" position without starting the engine.
Verify that all dashboard lights illuminate properly.

3. Reset Procedure

Press and hold the "Select/Reset" button located on the instrument panel.
While holding the button, turn the ignition switch off.
Turn the ignition switch back to the "On" position without starting the engine.
Release the "Select/Reset" button once the maintenance light blinks and extinguishes.

4. Confirmation

Turn the ignition switch off and then back on to confirm that the maintenance light has been reset.