how to reset the maintenance light on Honda Pilot YF3 (2016-2022)

Honda Pilot Third Generation (2016-present)

Error Codes

5-10 minutes

Time

easy

Difficulty

low

Severity

3 min read

421 words

Problem Statement

Learn how to reset the maintenance light on Honda Pilot YF3 (2016-2022) with this step-by-step guide. Quick and easy procedure for vehicle maintenance.

Affected Component

Electrical

Estimated Time

5-10 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is parked safely before performing the reset procedure.
•Do not attempt to reset while driving.

Symptoms

•Maintenance light illuminated on the dashboard
•No other operational issues with the vehicle
•Possible reminder to perform routine maintenance

Diagnostic Steps

1
Turn the ignition to the 'ON' position without starting the engine.
2
Ensure that the odometer is set to the 'Trip A' mode.
3
Turn off the ignition.
4
Press and hold the 'Select/Reset' button on the dashboard.
5
While holding the button, turn the ignition back to the 'ON' position.
6
Continue holding the button until the maintenance light resets.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Vehicle key

Parts Required

•No parts are required for resetting the maintenance light.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Turn the ignition to the 'ON' position without starting the engine.
2
Ensure that the odometer is set to the 'Trip A' mode.
3
Turn off the ignition.
4
Press and hold the 'Select/Reset' button on the dashboard.
5
While holding the button, turn the ignition back to the 'ON' position.
6
Continue holding the button until the maintenance light resets.

Solution

1. Preparation

Ensure the vehicle is parked on a level surface with the ignition off.
Have the keys ready to access the ignition.

2. Turn Ignition On

Turn the ignition key to the "ON" position without starting the engine.
Confirm that all dashboard lights illuminate, including the maintenance light.

3. Set Odometer to Trip A

Use the "Select/Reset" button on the dashboard to toggle the display until "Trip A" is shown.
Ensure "Trip A" is selected before proceeding.

4. Power Off Ignition

Turn the ignition off completely. Do not remove the key or press the start button.

5. Reset Procedure

Press and hold the "Select/Reset" button on the dashboard.
While holding the button, turn the ignition back to the "ON" position.
Continue to hold the button for about 10 seconds until the maintenance light blinks and goes out.

6. Confirmation

Release the "Select/Reset" button.
Confirm that the maintenance light is off when the ignition is turned back to the "OFF" position and then back to "ON".