my Honda CR-V's power locks won't work with the remote what's going on

Honda CR-V Sixth Generation (2023-present)

Error Codes

1-2 hours

Time

medium

Difficulty

medium

Severity

3 min read

479 words

Problem Statement

Learn how to diagnose and fix power locks not working on Honda CR-V. Step-by-step guide with symptoms, diagnostic steps, and repair instructions.

Affected Component

Electrical

Estimated Time

1-2 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the vehicle battery if working on electrical components to prevent shorts.

Symptoms

•Remote key fob does not unlock or lock the doors
•Key fob LED light does not illuminate when buttons are pressed
•Power locks work manually with the key or interior switch
•Possible 'keyless entry' warning light illuminated on the dashboard
•Weak or dead battery in the remote key fob

Diagnostic Steps

1
Check the battery in the remote key fob for voltage and replace if necessary.
2
Inspect the key fob for physical damage or wear.
3
Use an OBD-II scanner to check for any related error codes.
4
Test the power lock switch on the driver's door for functionality.
5
Verify the vehicle's battery voltage to ensure it's within acceptable limits.
6
Check the vehicle's fuse box for any blown fuses related to the central locking system.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Small flathead screwdriver
•Screwdriver set
•Multimeter
•Fuse puller or needle-nose pliers

Parts Required

•New key fob battery (CR2032 or CR2025)
•Replacement power lock switch (if defective)
•Replacement fuses (if applicable)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Check the battery in the remote key fob for voltage and replace if necessary.
2
Inspect the key fob for physical damage or wear.
3
Use an OBD-II scanner to check for any related error codes.
4
Test the power lock switch on the driver's door for functionality.
5
Verify the vehicle's battery voltage to ensure it's within acceptable limits.
6
Check the vehicle's fuse box for any blown fuses related to the central locking system.

Solution

1. Replace Key Fob Battery

Tools Required: Small flathead screwdriver, new battery (typically CR2032 or CR2025)
Open the key fob using the flathead screwdriver to avoid damage.
Remove the old battery and replace it with a new one, ensuring correct polarity.
Reassemble the key fob.

2. Inspect and Test the Key Fob

Check for any visible damage on the key fob housing.
Test the key fob again after replacing the battery.
If it still does not work, consider reprogramming the key fob using the vehicle's manual instructions.

3. Inspect Power Lock Switch

Tools Required: Screwdriver set
Remove the door panel to access the power lock switch.
Disconnect the switch and test it with a multimeter for continuity.
Replace the switch if it does not function correctly.

4. Check Fuses

Tools Required: Fuse puller or needle-nose pliers
Locate the fuse box, usually under the dashboard or in the engine compartment.
Identify the fuse for the power locks (refer to the fuse diagram).
Replace any blown fuses with the correct amperage fuse.