how to reset EPS light on Honda CR-V Fifth Generation (2017-2022)?

Honda CR-V Sixth Generation (2023-present)

Error Codes

1 hour

Time

medium

Difficulty

medium

Severity

3 min read

477 words

Problem Statement

Learn how to reset the EPS light on Honda CR-V Fifth Generation (2017-2022). Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Steering

Estimated Time

1 hour

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on any electrical components to prevent shock or short circuits.

Symptoms

•EPS warning light illuminated on the dashboard
•Steering feels heavy or unresponsive
•Unusual noises when turning the steering wheel
•Intermittent loss of power steering assistance
•Performance issues during tight turns

Diagnostic Steps

1
Scan the vehicle using an OBD-II scanner to check for any stored error codes related to the EPS system.
2
Inspect the power steering fluid level and condition; top up or replace if necessary.
3
Check the vehicle’s battery voltage; a weak battery can affect the EPS system.
4
Visually inspect the wiring and connectors related to the EPS system for any signs of damage or corrosion.
5
Disconnect and reconnect the EPS system’s electrical connector to reset any temporary faults.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Torque wrench

Parts Required

•Honda power steering fluid

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Scan the vehicle using an OBD-II scanner to check for any stored error codes related to the EPS system.
2
Inspect the power steering fluid level and condition; top up or replace if necessary.
3
Check the vehicle’s battery voltage; a weak battery can affect the EPS system.
4
Visually inspect the wiring and connectors related to the EPS system for any signs of damage or corrosion.
5
Disconnect and reconnect the EPS system’s electrical connector to reset any temporary faults.

Solution

1. Preparation

Gather all necessary tools and parts.
Ensure the vehicle is parked on a flat surface and the engine is off.
Disconnect the negative battery terminal to prevent electrical shorts.

2. Inspect and Reset EPS System

Inspect Power Steering Fluid:
- Locate the power steering fluid reservoir.
- Check fluid level against the minimum and maximum marks; refill with Honda power steering fluid if low.
Reconnect Battery:
- After checking the fluid, reconnect the negative battery terminal securely.
- Ensure all connections are tight to prevent electrical issues.
Clear Error Codes:
- Use the OBD-II scanner to clear any stored codes related to the EPS system if present.
- Follow the scanner's instructions to erase the codes effectively.
Perform EPS Reset Procedure:
- Turn the ignition key to the ON position without starting the engine.
- Wait for about 10 seconds, then turn the steering wheel fully left and right (lock to lock) to recalibrate the EPS system.

3. Final Check

Start the vehicle and observe if the EPS light remains off.
Test the steering for responsiveness and ease of movement.