how to change the cabin air filter in Honda CR-V Fifth Generation (2017-2022)

Honda CR-V 6th Gen (2023-Present)

Error Codes

30-60 minutes

Time

medium

Difficulty

medium

Severity

3 min read

482 words

Problem Statement

Learn how to change the cabin air filter in a Honda CR-V (2017-2022) to improve air quality and HVAC performance. Step-by-step guide included.

Affected Component

HVAC

Estimated Time

30-60 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical components (optional)

Symptoms

•Reduced airflow from the HVAC system
•Unpleasant odors inside the cabin
•Increased dust or debris accumulation on interior surfaces
•Frequent fogging of windows
•Check cabin air filter light illuminated (if equipped)

Diagnostic Steps

1
Confirm the need for replacement by inspecting the filter for dirt and debris.
2
Check the owner’s manual for the cabin air filter replacement interval.
3
Verify if the HVAC system is functioning properly before replacing the filter.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Flathead screwdriver
•Phillips screwdriver
•Safety gloves

Parts Required

•New cabin air filter

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Tools Required: Flathead screwdriver, Phillips screwdriver, safety gloves.
Ensure the vehicle is parked on a level surface, and the engine is turned off.
Open the hood and disconnect the negative battery terminal for safety (optional).

2. Locate the Cabin Air Filter

Open the glove compartment and remove all contents.
Locate the damper on the right side of the glove compartment and disconnect it by squeezing the sides and pulling it away.

3. Remove the Glove Compartment

Use a Phillips screwdriver to remove the screws holding the glove compartment in place.
Once the screws are removed, gently pull the glove compartment out to access the filter compartment.

4. Replace the Cabin Air Filter

Locate the cabin air filter cover, which is usually a rectangular panel.
Unclip or unscrew the cover to access the cabin air filter.
Carefully pull out the old cabin air filter, taking note of its orientation (airflow direction).
Insert the new cabin air filter, ensuring it is oriented properly according to the airflow arrows.

5. Reassemble

Reattach the cabin air filter cover by clipping or securing it with screws.
Reinstall the glove compartment by reversing the removal steps.
Reconnect the damper to the glove compartment sides.
Replace all contents back into the glove compartment.

6. Final Checks

Reconnect the negative battery terminal (if disconnected).
Close the glove compartment and ensure it opens and closes smoothly.