why does my Honda CR-V Sixth Generation (2023-present) make a clicking noise when I turn

Honda CR-V Fifth Generation (2017-2022)

Error Codes

2-4 hours

Time

medium

Difficulty

medium

Severity

3 min read

462 words

Problem Statement

Learn how to diagnose and fix the clicking noise when turning in Honda CR-V Sixth Generation. Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Suspension

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Always use jack stands when working under a vehicle.
•Disconnect the battery before working on electrical components.

Symptoms

•Clicking noise when turning the steering wheel
•Noise increases with sharper turns
•Possible feeling of resistance in the steering wheel
•Vibration in the steering column
•Uneven tire wear

Diagnostic Steps

1
Inspect the front suspension components for any visible signs of wear or damage.
2
Check the CV joints and boots for tears or leaks.
3
Test drive the vehicle to replicate the clicking noise and note the conditions (speed, degree of turn).
4
Scan for any error codes using an OBD-II scanner to rule out electronic issues.
5
Verify the tightness of all bolts and fasteners in the steering assembly and suspension.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Jack
•Jack stands
•Wheel chocks
•Socket set
•Torque wrench

Parts Required

•CV joint or boot (if damaged)
•Suspension components (if worn or damaged)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Inspect the front suspension components for any visible signs of wear or damage.
2
Check the CV joints and boots for tears or leaks.
3
Test drive the vehicle to replicate the clicking noise and note the conditions (speed, degree of turn).
4
Scan for any error codes using an OBD-II scanner to rule out electronic issues.
5
Verify the tightness of all bolts and fasteners in the steering assembly and suspension.

Solution

1. Preparation

Tools Required: Jack, jack stands, wheel chocks, socket set, torque wrench.
Ensure the vehicle is on a flat surface.
Disconnect the battery to prevent any electrical issues while working on the vehicle.

2. Inspect Suspension Components

Sub-steps:
1. Raise the front of the vehicle using a jack and secure it with jack stands.
2. Remove the front wheels to gain access to the suspension components.
3. Inspect the lower control arms, struts, and sway bar links for any signs of damage or wear.
4. Check for any loose nuts or bolts and tighten them to factory specifications.

3. Examine CV Joints

Sub-steps:
1. Inspect the CV joint boots for any cracks or leaks.
2. If any damage is found, replace the CV joint or boot as necessary.
3. If the CV joint is intact, apply a small amount of grease if it was low.

4. Reassemble and Test

Sub-steps:
1. Reinstall the wheels and lower the vehicle back to the ground.
2. Reconnect the battery.
3. Test drive the vehicle to ensure the clicking noise has been resolved.