how to reset maintenance light on Honda CR-V Fifth Generation (2017-2022)

Honda CR-V Fifth Generation (2017-2022)

Error Codes

5 minutes

Time

easy

Difficulty

low

Severity

2 min read

366 words

Problem Statement

Learn how to reset the maintenance light on Honda CR-V (2017-2022) with this step-by-step guide. Quick and easy instructions for your vehicle.

Affected Component

Electrical

Estimated Time

5 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is stationary and on a flat surface before performing the reset.

Symptoms

•Maintenance light illuminated on the dashboard
•No other warning lights present
•Vehicle has undergone routine maintenance (e.g., oil change, tire rotation)

Diagnostic Steps

1
Ensure the vehicle is in the 'On' position without starting the engine.
2
Confirm that all doors are closed.
3
Access the trip meter display on the instrument panel.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•None

Parts Required

•None

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather necessary tools: None required for this process.
Ensure the vehicle is parked on a level surface and the engine is off.

2. Turn On the Ignition

Insert the key into the ignition and turn it to the "On" position, but do not start the engine. If equipped with a push-button start, press the button twice without pressing the brake pedal.

3. Access the Trip Meter

Use the trip meter button located on the dashboard to navigate to the "Trip A" display. The display should read "Trip A" before proceeding.

4. Reset the Maintenance Light

Press and hold the trip meter reset button.
While holding the button, turn the ignition to the "Off" position and then back to the "On" position, still holding the button.
Continue holding the button until the maintenance light starts to blink and then turns off. This may take about 10 seconds.

5. Confirm Reset

Release the trip meter reset button.
Turn off the ignition and then start the vehicle to ensure the maintenance light is no longer illuminated.