Honda CR-V Fifth Generation (2017-2022) engine light is on, how do I reset it?

Honda CR-V Fifth Generation (2017-2022)

Error Codes

30 minutes to 1 hour

Time

medium

Difficulty

medium

Severity

3 min read

449 words

Problem Statement

Learn how to reset the engine light on your Honda CR-V (2017-2022). Step-by-step diagnostic and reset procedures included.

Affected Component

Engine

Estimated Time

30 minutes to 1 hour

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical systems.

Symptoms

•Check engine light illuminated
•Possible decrease in vehicle performance
•Potential for other warning lights to appear
•Engine running rough or erratic
•No noticeable changes in driving behavior

Diagnostic Steps

1
Scan for error codes using an OBD-II scanner to identify the underlying issue.
2
Investigate the reason behind the check engine light; this may involve checking fluid levels, inspecting the gas cap, or reviewing recent repairs.
3
Clear the error codes using the OBD-II scanner after addressing any underlying issues.
4
Disconnect the vehicle's battery for a few minutes as an alternative method to reset the engine light.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Wrench set

Parts Required

•Battery
•Sensor

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Scan for error codes using an OBD-II scanner to identify the underlying issue.
2
Investigate the reason behind the check engine light; this may involve checking fluid levels, inspecting the gas cap, or reviewing recent repairs.
3
Clear the error codes using the OBD-II scanner after addressing any underlying issues.
4
Disconnect the vehicle's battery for a few minutes as an alternative method to reset the engine light.

Solution

1. Preparation

Gather necessary tools and parts.
Ensure the vehicle is parked on a level surface and the engine is off.

Tools Required:

OBD-II scanner
Wrench set (for battery disconnection)

2. Scan for Codes

Connect the OBD-II scanner to the vehicle's OBD-II port, typically located under the dashboard near the steering column.
Turn the ignition to the "On" position without starting the engine.
Follow the scanner instructions to read the codes.

3. Address Underlying Issues

If codes are present, investigate and resolve the cause (e.g., replace faulty sensors, tighten the gas cap).
If no issues are found, proceed to the next step.

4. Clear Error Codes

Using the OBD-II scanner, select the option to clear or erase the error codes.
Confirm the action and wait for the scanner to indicate that the codes have been successfully cleared.

5. Disconnect Battery (Optional)

If preferred, turn off the ignition and use a wrench to disconnect the negative terminal of the battery.
Wait for approximately 5-10 minutes before reconnecting the terminal.
Reconnect the negative terminal and ensure it is secure.