how to reset the tire pressure light on Honda Civic 10th Generation (2016-2021)

Honda Civic 11th Generation (2022-Present)

15-30 minutes

Time

easy

Difficulty

medium

Severity

3 min read

445 words

Problem Statement

Learn how to reset the tire pressure light on Honda Civic 10th Generation (2016-2021). Step-by-step guide with diagnostic steps and solutions.

Affected Component

Electrical

Estimated Time

15-30 minutes

Important safety information - read before proceeding

•Ensure the vehicle is parked on a level surface before checking tire pressures.

1
Check all tire pressures using a tire pressure gauge to ensure they are at the manufacturer-recommended PSI.
2
Inspect each tire for visible signs of damage or air leaks.
3
Ensure that the spare tire, if equipped with a TPMS sensor, is also properly inflated.
4
Refer to the vehicle's owner's manual for specific TPMS reset instructions.
5
Note any recent changes to tire pressure or tire replacement that could affect the TPMS.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Check all tire pressures using a tire pressure gauge to ensure they are at the manufacturer-recommended PSI.
2
Inspect each tire for visible signs of damage or air leaks.
3
Ensure that the spare tire, if equipped with a TPMS sensor, is also properly inflated.
4
Refer to the vehicle's owner's manual for specific TPMS reset instructions.
5
Note any recent changes to tire pressure or tire replacement that could affect the TPMS.

Solution

1. Preparation

Ensure all tires are inflated to the recommended tire pressure (check placard on the driver's side door jamb).
Gather necessary tools: tire pressure gauge.

2. Reset TPMS

Locate the TPMS Reset Button
- The TPMS reset button is usually located below the steering column or in the glove box.
Turn on the Ignition
- Insert the key and turn the ignition to the "ON" position without starting the engine.
Press and Hold the TPMS Reset Button
- Press and hold the TPMS reset button until the TPMS indicator blinks three times and then goes off, indicating the system is resetting.
Start the Engine
- Start the engine, and allow it to run for a few minutes to complete the reset process.
Verify the Light Status
- After a few minutes, check if the TPMS light remains off. If it stays illuminated, repeat the reset process or check tire pressures again.