how to reset the maintenance light on Honda Civic 10th Generation (2016-2021)

Honda Civic 11th Generation (2022-Present)

Error Codes

5 minutes

Time

easy

Difficulty

low

Severity

2 min read

345 words

Problem Statement

Learn how to reset the maintenance light on Honda Civic 10th Generation (2016-2021) with this simple step-by-step guide. Quick and easy instructions.

Affected Component

Electrical

Estimated Time

5 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in 'Park' or 'Neutral' before performing the reset.

Symptoms

•Maintenance light illuminated on the dashboard
•Engine oil light may also be on
•No other warning lights present
•Vehicle running normally aside from the maintenance light

Diagnostic Steps

1
Ensure the vehicle is in the 'OFF' position.
2
Turn the ignition to the 'ON' position without starting the engine.
3
Press the gas pedal three times within 5 seconds.
4
Check if the maintenance light blinks and then turns off after a few seconds.
5
Turn the ignition back to the 'OFF' position.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•None

Parts Required

•None

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather necessary tools: none required for this procedure.
Ensure the vehicle is parked safely with the engine off.

2. Ignition Sequence

Insert the key into the ignition or press the start button without pressing the brake pedal.
Turn the ignition to the "ON" position (the dashboard lights will illuminate, but the engine should not start).

3. Reset Procedure

With the ignition in the "ON" position, press the gas pedal three times slowly and fully.
Observe the maintenance light on the dashboard. It should blink and then turn off, indicating that the reset was successful.

4. Final Steps

Turn the ignition back to the "OFF" position.
Wait a few seconds and then start the vehicle to verify that the maintenance light is no longer illuminated.