how to reset the check engine light on my Honda Civic 10th Generation (2016-2021)?

Honda Civic 11th Generation (2022-Present)

Error Codes

15-30 minutes

Time

easy

Difficulty

medium

Severity

2 min read

381 words

Problem Statement

Learn how to reset the check engine light on your Honda Civic 10th Generation (2016-2021) with this step-by-step guide. Ensure your vehicle runs smoothly.

Affected Component

Electrical

Estimated Time

15-30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in a safe location with the engine off during the reset process.

Symptoms

•Check engine light illuminated
•Potential error codes stored in the vehicle's computer
•Vehicle may run normally or experience symptoms related to the underlying issue

Diagnostic Steps

1
Use an OBD-II scanner to check for any error codes.
2
Note the error codes and corresponding issues before proceeding with the reset.
3
Verify if the issue causing the check engine light has been resolved.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner

Parts Required

•None required for the reset process.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Tools Required: OBD-II scanner
Ensure the vehicle is parked on a flat surface with the engine turned off.
Open the driver's side door to access the OBD-II port, typically located under the dashboard.

2. Connect OBD-II Scanner

Plug the OBD-II scanner into the vehicle's OBD-II port.
Turn the vehicle's ignition to the "On" position (do not start the engine).

3. Access Error Codes

Follow the scanner's instructions to navigate to the error codes section.
Review and note any error codes displayed.

4. Clear Error Codes

Select the option to erase or clear codes from the scanner menu.
Confirm the action when prompted by the scanner.
Wait for the scanner to display a confirmation message that the codes have been cleared.

5. Disconnect Scanner

Safely unplug the OBD-II scanner from the port.
Close the vehicle's ignition and wait a moment.

6. Test Drive

Start the engine and take the vehicle for a short test drive to ensure the check engine light remains off.