how to reset check engine light on Honda Civic 10th Generation (2016-2021)

Honda Civic 11th Generation (2022-Present)

Error Codes

15-30 minutes

Time

easy

Difficulty

medium

Severity

2 min read

363 words

Problem Statement

Learn how to reset the check engine light on Honda Civic 10th Generation (2016-2021). Step-by-step guide with diagnostic procedures and tools required.

Affected Component

Electrical

Estimated Time

15-30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in a safe and stable position before working on the electrical systems.

Symptoms

•Check engine light illuminated
•Engine performance may be affected (if not yet repaired)
•Reduced fuel economy (if applicable)
•Potential diagnostic trouble codes stored in the ECU

Diagnostic Steps

1
Use an OBD-II scanner to check for diagnostic trouble codes (DTCs) that triggered the check engine light.
2
Address any mechanical issues or faults indicated by the codes.
3
Clear the DTCs using the OBD-II scanner.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Vehicle owner's manual

Parts Required

•None required specifically for resetting the check engine light.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather tools: OBD-II scanner, vehicle owner's manual.
Ensure the vehicle is parked on a level surface and the engine is off.

2. Connect OBD-II Scanner

Locate the OBD-II port under the dashboard, usually near the driver's side.
Plug the OBD-II scanner into the port.

3. Read Diagnostic Codes

Turn on the vehicle ignition without starting the engine.
Follow the scanner’s instructions to read and note any stored DTCs.

4. Clear Codes

Using the OBD-II scanner, navigate to the function to clear or erase codes.
Select the option to reset the check engine light and confirm the action.

5. Disconnect Scanner

Once the codes are cleared, safely disconnect the OBD-II scanner from the port.

6. Test Drive

Start the vehicle and take it for a short test drive to ensure the check engine light remains off.