why does my Honda Civic make a clicking noise when turning

Honda Civic 10th Generation (2016-2021)

Error Codes

2-4 hours

Time

medium

Difficulty

medium

Severity

3 min read

481 words

Problem Statement

Learn how to diagnose and fix clicking noise when turning in Honda Civic. Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Suspension

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect battery before working on electrical systems.
•Allow the vehicle to cool before inspecting engine or transmission components.

Symptoms

•Clicking noise during sharp turns
•Noise increases with speed
•Vibration felt in the steering wheel
•Possible loss of steering responsiveness
•Uneven tire wear (over time)

Diagnostic Steps

1
Inspect the front axle and CV joints for visible damage or wear.
2
Check for loose or damaged suspension components, such as tie rods and control arms.
3
Examine the wheel bearings for signs of wear or noise when spinning the wheel by hand.
4
Test the CV joints by performing a dry turn in a safe environment and listening for noise.
5
Inspect the tire tread and sidewalls for unusual wear or bulges.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Socket set
•Torque wrench
•CV joint grease
•Jack and jack stands
•Bearing puller

Parts Required

•CV joint or axle assembly
•Wheel bearings

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Inspect the front axle and CV joints for visible damage or wear.
2
Check for loose or damaged suspension components, such as tie rods and control arms.
3
Examine the wheel bearings for signs of wear or noise when spinning the wheel by hand.
4
Test the CV joints by performing a dry turn in a safe environment and listening for noise.
5
Inspect the tire tread and sidewalls for unusual wear or bulges.

Solution

1. Preparation

Gather tools and parts needed for the repair.
Park the vehicle on a flat surface, engage the parking brake, and disconnect the battery for safety.

2. Inspect and Replace CV Joints

Tools Required: Socket set, torque wrench, CV joint grease, jack and jack stands.
Lift the front of the vehicle using a jack and secure it with jack stands.
Remove the wheel to access the CV joint.
Inspect the CV joint boot for tears or leakage.
If damaged, remove the axle nut and disconnect the CV joint from the hub.
Pull the axle out of the transmission and replace the CV joint or the entire axle as necessary.
Reinstall the axle, ensuring the new CV joint is properly greased and the boot is secure.
Torque the axle nut to manufacturer specifications.

3. Inspect and Replace Wheel Bearings

Tools Required: Bearing puller, socket set, torque wrench.
After removing the wheel, check the wheel bearings for excessive play or roughness.
If worn, remove the hub assembly to access the bearings.
Use a bearing puller to remove old bearings and install new ones.
Reassemble the hub and wheel, ensuring all components are torqued to specifications.