how to fix Honda Civic 10th Generation (2016-2021) strut noise when hitting bumps

Honda Civic 10th Generation (2016-2021)

Error Codes

2-4 hours

Time

medium

Difficulty

medium

Severity

3 min read

529 words

Problem Statement

Learn how to diagnose and fix strut noise in Honda Civic 10th Generation (2016-2021). Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Suspension

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Always use jack stands when working under the vehicle.
•Disconnect the battery before working on electrical components.

Symptoms

•Clunking or rattling noise when driving over bumps
•Diminished ride quality or comfort
•Increased body roll during cornering
•Uneven tire wear
•Visible oil leakage from strut assembly

Diagnostic Steps

1
Inspect the strut assembly visually for signs of damage or leakage.
2
Check the strut mounts for wear or separation.
3
Perform a bounce test to assess strut performance.
4
Examine the anti-roll bar links for play or damage.
5
Verify the condition of the coil springs for cracks or breaks.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Hydraulic jack
•Jack stands
•Socket set
•Wrench set
•Torque wrench
•Screwdriver set

Parts Required

•New strut assembly (if needed)
•New strut mounts (if needed)
•New coil springs (if needed)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather tools and parts.
Park the vehicle on a level surface and engage the parking brake.
Disconnect the battery to ensure safety during repairs.

2. Lift the Vehicle

Use a hydraulic jack to lift the front or rear of the vehicle, depending on which strut is affected.
Secure the vehicle with jack stands.

3. Remove Wheel

Use a socket set to remove the lug nuts and take off the wheel.
Store the lug nuts in a safe place for reinstallation.

4. Remove Strut Assembly

Detach the brake line and ABS sensor wire from the strut (if equipped) using a wrench.
Remove the lower strut bolts using a socket and ratchet.
Disconnect the strut mount nuts at the top of the strut tower using a socket.
Carefully remove the strut assembly from the vehicle.

5. Inspect and Replace Components

Check the strut for oil leakage; if leaking, replace the strut.
Inspect strut mounts for wear; replace if necessary.
Inspect the coil springs for damage; replace if cracked.

6. Install New or Repaired Strut

Position the new or repaired strut assembly into place.
Reattach the strut mount nuts and lower strut bolts, tightening to manufacturer specifications (usually around 50-70 ft-lbs).
Reconnect the brake line and ABS sensor wire.

7. Reinstall Wheel and Lower Vehicle

Place the wheel back onto the hub and hand-tighten the lug nuts.
Lower the vehicle from the jack stands and fully tighten the lug nuts in a criss-cross pattern to the specified torque (typically 80-100 ft-lbs).