how to fix CV joint noise on Honda Civic 10th Generation (2016-2021)

Honda Civic 10th Generation (2016-2021)

Error Codes

2-4 hours

Time

medium

Difficulty

medium

Severity

3 min read

562 words

Problem Statement

Learn how to diagnose and fix CV joint noise in Honda Civic 10th Generation (2016-2021). Step-by-step guide with symptoms, diagnostic steps, and repair instructions.

Affected Component

Suspension

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Always wear safety glasses and gloves when working on the vehicle.
•Ensure the vehicle is securely supported on jack stands before working underneath.

Symptoms

•Clicking or popping noise during turns
•Grease leakage around the CV joint area
•Vibration during acceleration
•Increased noise during acceleration
•Unusual sounds when driving over bumps

Diagnostic Steps

1
Inspect the CV boot for tears or damage.
2
Check for grease leakage around the CV joint.
3
Test drive the vehicle to confirm noise during turns and acceleration.
4
Assess for any play in the CV joint by manually shaking the axle.
5
Inspect the suspension components for any related issues.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Jack and jack stands
•Socket set
•Torque wrench
•Pry bar
•CV joint puller
•Clean rags

Parts Required

•New CV joint assembly
•CV boot kit
•CV joint grease

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather all necessary tools and parts.
Park the vehicle on a flat surface and engage the parking brake.
Disconnect the negative battery terminal for safety.

Tools Required:

Jack and jack stands
Socket set
Torque wrench
Pry bar
CV joint puller (if necessary)
Clean rags

2. Remove the Wheel

Loosen the lug nuts slightly while the vehicle is on the ground.
Jack up the vehicle and secure it with jack stands.
Remove the wheel completely.

3. Remove the CV Joint Assembly

3.1. Locate the axle nut and remove it using the appropriate socket size.
3.2. Use a pry bar to gently separate the CV joint from the hub assembly if needed.
3.3. If necessary, use a CV joint puller to detach the CV joint from the transmission side.
3.4. Pull the entire CV axle out of the hub assembly.

4. Inspect and Replace the CV Joint

4.1. Inspect the CV joint for wear or damage, paying attention to the bearings and race.
4.2. If damaged, remove the old CV joint by cutting the boot and sliding the joint off the axle.
4.3. Install the new CV joint by sliding it onto the axle and securing it with a new boot and clamps.
4.4. Apply the recommended amount of CV joint grease as per the manufacturer's specifications.

5. Reassemble the Components

5.1. Reinsert the axle into the hub assembly and tighten the axle nut to the manufacturer's torque specification.
5.2. Reattach the wheel and hand-tighten the lug nuts.
5.3. Lower the vehicle and then fully tighten the lug nuts to the specified torque value.