my Honda Accord makes a loud noise when turning what might be wrong

Honda Accord 9th Generation (2013-2017)

Error Codes

2-4 hours

Time

medium

Difficulty

medium

Severity

3 min read

486 words

Problem Statement

Learn how to diagnose and fix loud noise when turning in Honda Accord. Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Steering

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Always engage the parking brake and use jack stands when lifting the vehicle.
•Disconnect the battery before working on electrical systems.

Symptoms

•Loud grinding or clunking noise during turns
•Increased steering resistance or difficulty
•Vibration in the steering wheel when turning
•Uneven tire wear
•Warning lights illuminated on the dashboard (if applicable)

Diagnostic Steps

1
Inspect the power steering fluid level and condition.
2
Check for any visible leaks in the steering or suspension components.
3
Listen for noise while turning the steering wheel in place (stationary).
4
Examine the CV joints and boots for signs of wear or damage.
5
Inspect the wheel bearings for play or roughness.
6
Check tire pressure and condition.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Socket set
•Torque wrench
•Jack and jack stands
•Fluid pump (for power steering fluid)

Parts Required

•Power steering fluid
•CV joint assembly (if worn)
•Wheel bearing (if needed)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Inspect the power steering fluid level and condition.
2
Check for any visible leaks in the steering or suspension components.
3
Listen for noise while turning the steering wheel in place (stationary).
4
Examine the CV joints and boots for signs of wear or damage.
5
Inspect the wheel bearings for play or roughness.
6
Check tire pressure and condition.

Solution

1. Preparation

Gather necessary tools and parts.
Park the vehicle on a level surface and engage the parking brake.
Disconnect the battery to prevent any electrical issues.

2. Inspect and Replace Power Steering Fluid

Locate the power steering fluid reservoir.
Remove the cap and check the fluid level; if low, top up with manufacturer-recommended fluid.
If the fluid is dirty or contaminated, drain and replace it.

3. Replace Worn CV Joints

Lift the front of the vehicle using a jack and secure it with jack stands.
Remove the wheel to access the CV joint.
Unbolt the CV joint from the transmission and steering knuckle.
Install the new CV joint, ensuring it is properly greased and secured with the appropriate torque specifications.

4. Inspect and Replace Wheel Bearings (if necessary)

Remove the wheel and brake assembly to access the hub.
Check for play in the wheel bearing by rocking the wheel back and forth.
If worn, remove the hub assembly and replace the bearing with a new one, ensuring proper alignment and torque.

5. Reassemble and Lower Vehicle

Reattach the wheel and secure lug nuts to the manufacturer’s torque specifications.
Reconnect the battery.
Lower the vehicle from the jack stands.