my Honda Accord makes a clicking noise when I use the turn signal, what’s wrong?

Honda Accord 9th Generation (2013-2017)

Error Codes

1-3 hours

Time

medium

Difficulty

medium

Severity

3 min read

476 words

Problem Statement

Learn to diagnose and fix the clicking noise when using the turn signal in Honda Accord. Step-by-step guide with symptoms, diagnostics, and repair instructions.

Affected Component

Electrical

Estimated Time

1-3 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical systems to avoid short circuits or shocks.

Symptoms

•Clicking noise when turn signal is activated
•Turn signal does not work intermittently or at all
•Dashboard indicator lights flash rapidly
•Possible failure of the hazard lights
•Lighting issues with exterior turn signals

Diagnostic Steps

1
Inspect the turn signal lever for any physical damage or wear.
2
Check the turn signal bulbs for burnout or corrosion.
3
Use an OBD-II scanner to check for any relevant error codes.
4
Inspect the wiring and connections at the turn signal switch and bulbs.
5
Test the turn signal relay for proper operation.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Socket set
•Screwdrivers
•Multimeter
•OBD-II scanner

Parts Required

•Turn signal bulbs
•Turn signal relay
•Turn signal switch (if needed)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather tools needed for the repair: socket set, screwdrivers, multimeter, and OBD-II scanner.
Disconnect the vehicle battery to ensure safety while working on electrical components.

2. Inspect and Replace Bulbs

Sub-step 1: Remove the bulb socket from the turn signal housing by turning it counterclockwise.
Sub-step 2: Check the bulb for any signs of damage or burn-out; replace if necessary.
Sub-step 3: Reinsert the new bulb into the socket and turn it clockwise to secure it.

3. Check and Replace the Turn Signal Relay

Sub-step 1: Locate the turn signal relay in the fuse box (refer to the owner's manual for exact location).
Sub-step 2: Remove the relay by pulling it straight out of the socket.
Sub-step 3: Install a new relay of the same type and specifications.

4. Replace the Turn Signal Switch

Sub-step 1: Remove the steering column cover by unscrewing the screws and carefully prying it off.
Sub-step 2: Disconnect the electrical harness from the turn signal switch.
Sub-step 3: Unscrew the turn signal switch from the steering column and replace it with a new switch.
Sub-step 4: Reconnect the electrical harness and reattach the steering column cover.