why is my Honda Accord 10th Generation (2018-2022) making a clunking noise when turning

Honda Accord 8th Generation (2008-2012)

Error Codes

2-4 hours

Time

medium

Difficulty

medium

Severity

3 min read

450 words

Problem Statement

Discover how to diagnose and fix clunking noise when turning in Honda Accord 10th Generation (2018-2022). Step-by-step guide with diagnostic and repair instructions.

Affected Component

Suspension

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical systems.
•Ensure the vehicle is secured on jack stands before working underneath.

Symptoms

•Clunking noise when making sharp turns
•Noise occurs during both left and right turns
•Possible vibration felt through the steering wheel
•Uneven tire wear
•Difficulty in steering or increased steering effort

Diagnostic Steps

1
Inspect the front suspension components for visible damage or wear.
2
Check the CV joints and boots for cracks or tears.
3
Examine the steering linkage and tie rod ends for play or looseness.
4
Perform a wheel alignment check to identify any misalignment.
5
Test drive the vehicle to replicate the noise and isolate the source.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Socket set
•Jack and jack stands
•Torque wrench
•Screwdrivers
•Pry bar

Parts Required

•Control arm bushings (if worn)
•CV axle (if damaged)
•Tie rod ends (if worn)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Inspect the front suspension components for visible damage or wear.
2
Check the CV joints and boots for cracks or tears.
3
Examine the steering linkage and tie rod ends for play or looseness.
4
Perform a wheel alignment check to identify any misalignment.
5
Test drive the vehicle to replicate the noise and isolate the source.

Solution

1. Preparation

Gather tools and parts needed for the repair.
Park the vehicle on a level surface and engage the parking brake.
Disconnect the battery for safety.

2. Inspect Suspension Components

Use a jack and jack stands to lift the front of the vehicle.
Remove the front wheels using a socket set.
Visually inspect the control arms, bushings, and struts for any signs of wear or damage.
Replace any worn or damaged components.

3. Inspect CV Joints

Examine the CV joints for any signs of grease leakage or damage.
If the CV boot is torn, replace the boot and ensure the joint is properly lubricated.
If the joint itself is damaged, replace the entire CV axle.

4. Check Steering Components

Inspect the tie rod ends and steering rack for play by moving them back and forth.
Tighten any loose connections or replace worn tie rods as necessary.

5. Reassemble and Test

Reinstall the front wheels and lower the vehicle.
Reconnect the battery.
Perform a test drive to ensure that the clunking noise has been resolved.