why does my Honda Accord 9th Generation (2013-2017) make a popping noise when turning?

Honda Accord Eleventh Generation (2023-present)

Error Codes

3-5 hours

Time

medium

Difficulty

medium

Severity

3 min read

501 words

Problem Statement

Learn how to diagnose and fix popping noise when turning in Honda Accord 9th Generation. Step-by-step guide with symptoms, diagnostic steps, and repair instructions.

Affected Component

Suspension

Estimated Time

3-5 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Always work on a level surface and use jack stands to secure the vehicle.
•Disconnect the battery before working on electrical components.

Symptoms

•Popping or clicking noise during turns
•Noise occurs when steering left or right
•Increased play in the steering wheel
•Vibration or roughness felt in the steering
•Possible clunking sound when going over bumps

Diagnostic Steps

1
Inspect the front suspension components visually for wear or damage.
2
Check the CV joints for tears or grease leakage.
3
Test drive the vehicle to replicate the noise while turning.
4
Lift the vehicle and perform a wheel shake test to check for play in the wheel bearings.
5
Inspect the steering rack and tie rod ends for any looseness.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Socket set
•Torque wrench
•Pry bar
•Wrench set

Parts Required

•CV joint or axle assembly
•Control arms or bushings (if worn)
•Tie rod ends (if worn)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Inspect the front suspension components visually for wear or damage.
2
Check the CV joints for tears or grease leakage.
3
Test drive the vehicle to replicate the noise while turning.
4
Lift the vehicle and perform a wheel shake test to check for play in the wheel bearings.
5
Inspect the steering rack and tie rod ends for any looseness.

Solution

1. Preparation

Gather necessary tools and components.
Safely lift and secure the vehicle on jack stands.
Disconnect the battery to prevent electrical issues.

2. Inspect and Replace CV Joints

Tools Required: Socket set, torque wrench, pry bar, grease.
Remove the wheel to access the CV axle.
Use a socket set to remove the axle nut and any retaining bolts.
Carefully pull the CV axle out from the wheel hub and inspect the joint for damage or wear.
If damaged, replace the CV joint or the entire axle with a new part.
Reinstall the new CV joint/axle, ensuring it is properly seated and secured with the axle nut to the manufacturer’s torque specification.

3. Check and Replace Suspension Components

Tools Required: Socket set, wrench set, torque wrench.
Inspect the control arms, ball joints, and bushings for wear.
If any components are worn or damaged, remove the affected part using a socket set.
Install new bushings or control arms, ensuring proper alignment.
Torque all bolts to the manufacturer’s specifications.

4. Inspect and Repair Steering Components

Tools Required: Socket set, torque wrench.
Check the tie rod ends and steering rack for play.
If any components are worn, replace them accordingly.
Reinstall components and ensure all fasteners are torqued to specification.