how to reset the tire pressure light on my Honda Accord 9th Generation (2013-2017)

Honda Accord Eleventh Generation (2023-present)

Error Codes

30 minutes to 1 hour

Time

medium

Difficulty

medium

Severity

3 min read

457 words

Problem Statement

Learn how to reset the tire pressure light on your Honda Accord 9th Generation (2013-2017). Step-by-step guide with diagnostic steps and solutions.

Affected Component

Electrical

Estimated Time

30 minutes to 1 hour

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is on a stable surface when checking tire pressure to avoid accidents.

Symptoms

•Tire pressure warning light is illuminated on the dashboard
•Possible decrease in ride comfort due to improper tire inflation
•Unusual tire wear may be evident
•Reduced fuel efficiency might occur if tires are under-inflated

Diagnostic Steps

1
Verify that all tires are properly inflated according to the manufacturer’s specifications.
2
Inspect each tire for visible damage or punctures that may affect pressure.
3
Check the spare tire (if applicable) to ensure it is also properly inflated.
4
Determine if the tire pressure monitoring system (TPMS) sensor may require reprogramming, particularly if tires have been rotated or replaced.
5
Scan the vehicle’s OBD-II system for any related error codes that might indicate a malfunction.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Tire pressure gauge
•Air compressor
•Owner’s manual

Parts Required

•None required for reset; replace TPMS sensors if faulty.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Verify that all tires are properly inflated according to the manufacturer’s specifications.
2
Inspect each tire for visible damage or punctures that may affect pressure.
3
Check the spare tire (if applicable) to ensure it is also properly inflated.
4
Determine if the tire pressure monitoring system (TPMS) sensor may require reprogramming, particularly if tires have been rotated or replaced.
5
Scan the vehicle’s OBD-II system for any related error codes that might indicate a malfunction.

Solution

1. Preparation

Ensure the vehicle is parked on a level surface and the engine is off.
Gather tools such as an air compressor, tire pressure gauge, and the vehicle's owner’s manual for reference.

2. Inflate Tires

Using a tire pressure gauge, check the pressure of each tire.
Inflate the tires to the recommended pressure listed in the owner’s manual or on the driver's door jamb placard.
Recheck the pressure after inflating to ensure accuracy.

3. Reset TPMS

Turn the ignition to the "ON" position without starting the engine.
Locate the TPMS reset button, which is usually found under the steering wheel or near the driver's side footwell.
Press and hold the TPMS reset button until the tire pressure light blinks three times, then release it.
Start the engine and wait for a few minutes for the system to reinitialize.

4. Verify Reset

Drive the vehicle for a short distance (about 10 minutes) to allow the system to recalibrate.
Observe the tire pressure light; it should turn off if the reset was successful.